On 5/6/20 6:11 PM, Johannes Thumshirn wrote:
Emulate ZONE_APPEND for SCSI disks using a regular WRITE(16) command
with a start LBA set to the target zone write pointer position.
In order to always know the write pointer position of a sequential write
zone, the write pointer of all zones is tracked using an array of 32bits
zone write pointer offset attached to the scsi disk structure. Each
entry of the array indicate a zone write pointer position relative to
the zone start sector. The write pointer offsets are maintained in sync
with the device as follows:
1) the write pointer offset of a zone is reset to 0 when a
REQ_OP_ZONE_RESET command completes.
2) the write pointer offset of a zone is set to the zone size when a
REQ_OP_ZONE_FINISH command completes.
3) the write pointer offset of a zone is incremented by the number of
512B sectors written when a write, write same or a zone append
command completes.
4) the write pointer offset of all zones is reset to 0 when a
REQ_OP_ZONE_RESET_ALL command completes.
Since the block layer does not write lock zones for zone append
commands, to ensure a sequential ordering of the regular write commands
used for the emulation, the target zone of a zone append command is
locked when the function sd_zbc_prepare_zone_append() is called from
sd_setup_read_write_cmnd(). If the zone write lock cannot be obtained
(e.g. a zone append is in-flight or a regular write has already locked
the zone), the zone append command dispatching is delayed by returning
BLK_STS_ZONE_RESOURCE.
To avoid the need for write locking all zones for REQ_OP_ZONE_RESET_ALL
requests, use a spinlock to protect accesses and modifications of the
zone write pointer offsets. This spinlock is initialized from sd_probe()
using the new function sd_zbc_init().
Co-developed-by: Damien Le Moal <Damien.LeMoal@xxxxxxx>
Signed-off-by: Johannes Thumshirn <johannes.thumshirn@xxxxxxx>
Reviewed-by: Christoph Hellwig <hch@xxxxxx>
Reviewed-by: Martin K. Petersen <martin.petersen@xxxxxxxxxx>
---
drivers/scsi/sd.c | 16 +-
drivers/scsi/sd.h | 43 ++++-
drivers/scsi/sd_zbc.c | 363 +++++++++++++++++++++++++++++++++++++++---
3 files changed, 392 insertions(+), 30 deletions(-)
Reviewed-by: Hannes Reinecke <hare@xxxxxxx>
Cheers,
Hannes
--
Dr. Hannes Reinecke Teamlead Storage & Networking
hare@xxxxxxx +49 911 74053 688
SUSE Software Solutions GmbH, Maxfeldstr. 5, 90409 Nürnberg
HRB 36809 (AG Nürnberg), Geschäftsführer: Felix Imendörffer
