Jean-Max Reymond a écrit :
hi,
The computer is an DELL 1600SC with SATA RAID.
At boot time, no disk are detected.
I have tried with Ubuntu Edgy and Fedora Core 6 and I have the same
troubles. Fedora Core 2 is running on the computer.
it seems that Dell CERC ATA100/4ch is not supported by any driver.
see
http://www.mail-archive.com/debian-kernel@xxxxxxxxxxxxxxxx/msg20989.html
the output of dmesg when running Fedora Core 2
megaraid is nicely found
megaraid: found 0x101e:0x1960:bus 1:slot 2:func 0
scsi3:Found MegaRAID controller at 0xe0822000, IRQ:201
megaraid: [6.62:1.03] detected 1 logical drives.
megaraid: supports extended CDBs.
megaraid: channel[0] is raid.
megaraid: channel[1] is raid.
megaraid: channel[2] is raid.
megaraid: channel[3] is raid.
scsi3 : LSI Logic MegaRAID 6.62 254 commands 16 targs 7 chans 7 luns
scsi3: scanning scsi channel 0 for logical drives.
Vendor: MegaRAID Model: LD 0 RAID5 714G Rev: 6.62
Type: Direct-Access ANSI SCSI revision: 02
SCSI device sda: 1464287232 512-byte hdwr sectors (749715 MB)
sda: asking for cache data failed
sda: assuming drive cache: write through
SCSI device sda: 1464287232 512-byte hdwr sectors (749715 MB)
sda: asking for cache data failed
sda: assuming drive cache: write through
sda: sda1 sda2 sda3 sda4 < sda5 >
Attached scsi disk sda at scsi3, channel 0, id 0, lun 0
scsi3: scanning scsi channel 1 for logical drives.
scsi3: scanning scsi channel 2 for logical drives.
scsi3: scanning scsi channel 4 [P0] for physical devices.
scsi3: scanning scsi channel 5 [P1] for physical devices.
scsi3: scanning scsi channel 6 [P2] for physical devices.
scsi3: scanning scsi channel 7 [P3] for physical devices
begin:vcard
fn:Jean-Max Reymond
n:Reymond;Jean-Max
org:CKR Solutions Open Source
email;internet:jmreymond@xxxxxxxxxxxxxxxxx
title:Responsable technique
tel;work:08 71 03 25 11
tel;fax:08 21 74 92 65
tel;cell:06 16 94 25 11
note:jabber: jmreymond@xxxxxxxxx
x-mozilla-html:FALSE
url:http://www.ckr-solutions.com
version:2.1
end:vcard
