Re: [PATCH v7 7/8] scsi: ufs-qcom: Delay specific time before gate ref clk

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu 06 Feb 00:33 PST 2020, Can Guo wrote:

> After enter hibern8, as UFS JEDEC ver 3.0 requires, a specific gating wait
> time is required before disable the device reference clock. If it is not
> specified, use the old delay.
> 
> Signed-off-by: Can Guo <cang@xxxxxxxxxxxxxx>
> Reviewed-by: Asutosh Das <asutoshd@xxxxxxxxxxxxxx>
> Reviewed-by: Hongwu Su <hongwus@xxxxxxxxxxxxxx>
> ---
>  drivers/scsi/ufs/ufs-qcom.c | 22 +++++++++++++++++++---
>  1 file changed, 19 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
> index 85d7c17..39eefa4 100644
> --- a/drivers/scsi/ufs/ufs-qcom.c
> +++ b/drivers/scsi/ufs/ufs-qcom.c
> @@ -833,6 +833,8 @@ static int ufs_qcom_bus_register(struct ufs_qcom_host *host)
>  
>  static void ufs_qcom_dev_ref_clk_ctrl(struct ufs_qcom_host *host, bool enable)
>  {
> +	unsigned long gating_wait;
> +
>  	if (host->dev_ref_clk_ctrl_mmio &&
>  	    (enable ^ host->is_dev_ref_clk_enabled)) {
>  		u32 temp = readl_relaxed(host->dev_ref_clk_ctrl_mmio);
> @@ -845,11 +847,25 @@ static void ufs_qcom_dev_ref_clk_ctrl(struct ufs_qcom_host *host, bool enable)
>  		/*
>  		 * If we are here to disable this clock it might be immediately
>  		 * after entering into hibern8 in which case we need to make
> -		 * sure that device ref_clk is active at least 1us after the
> +		 * sure that device ref_clk is active for specific time after
>  		 * hibern8 enter.
>  		 */
> -		if (!enable)
> -			udelay(1);
> +		if (!enable) {
> +			gating_wait = host->hba->dev_info.clk_gating_wait_us;
> +			if (!gating_wait) {

Afaict this can't happen, because in patch 6 you check for gating_wait
being 0 and if so set it to 0xff.

> +				udelay(1);
> +			} else {
> +				/*
> +				 * bRefClkGatingWaitTime defines the minimum
> +				 * time for which the reference clock is
> +				 * required by device during transition from
> +				 * HS-MODE to LS-MODE or HIBERN8 state. Give it
> +				 * more time to be on the safe side.
> +				 */
> +				gating_wait += 10;
> +				usleep_range(gating_wait, gating_wait + 10);

I presume there's no strong requirement on the max, so how about using a
substantially larger max - say 1k, or 10k - to allow the usleep_range()
to do it's job?


PS. Please include linux-arm-msm@ on all the patches in the series, not
just two of them.

Regards,
Bjorn

> +			}
> +		}
>  
>  		writel_relaxed(temp, host->dev_ref_clk_ctrl_mmio);
>  
> -- 
> The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
> a Linux Foundation Collaborative Project



[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Index of Archives]     [SCSI Target Devel]     [Linux SCSI Target Infrastructure]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Linux IIO]     [Samba]     [Device Mapper]

  Powered by Linux