The order of the flags/checks for adapters where FC-AL is supported
erroneously excluded lpe35000 adapter models. Also noted that the G7
flags for Loop and Persistent topology are incorrect. They should follow
the rules as G6.
Rework the logic to enable LPe35000 FC-AL support.
Collapse G7 support logic to the same rules as G6.
Signed-off-by: Dick Kennedy <dick.kennedy@xxxxxxxxxxxx>
Signed-off-by: James Smart <jsmart2021@xxxxxxxxx>
---
drivers/scsi/lpfc/lpfc_attr.c | 9 ++++-----
drivers/scsi/lpfc/lpfc_init.c | 8 --------
2 files changed, 4 insertions(+), 13 deletions(-)
diff --git a/drivers/scsi/lpfc/lpfc_attr.c b/drivers/scsi/lpfc/lpfc_attr.c
index 4ff82b36a37a..46f56f30f77e 100644
--- a/drivers/scsi/lpfc/lpfc_attr.c
+++ b/drivers/scsi/lpfc/lpfc_attr.c
@@ -4123,14 +4123,13 @@ lpfc_topology_store(struct device *dev, struct device_attribute *attr,
/*
* The 'topology' is not a configurable parameter if :
* - persistent topology enabled
- * - G7 adapters
- * - G6 with no private loop support
+ * - G7/G6 with no private loop support
*/
- if (((phba->hba_flag & HBA_PERSISTENT_TOPO) ||
+ if ((phba->hba_flag & HBA_PERSISTENT_TOPO ||
(!phba->sli4_hba.pc_sli4_params.pls &&
- phba->pcidev->device == PCI_DEVICE_ID_LANCER_G6_FC) ||
- phba->pcidev->device == PCI_DEVICE_ID_LANCER_G7_FC) &&
+ (phba->pcidev->device == PCI_DEVICE_ID_LANCER_G6_FC ||
+ phba->pcidev->device == PCI_DEVICE_ID_LANCER_G7_FC))) &&
val == 4) {
lpfc_printf_vlog(vport, KERN_ERR, LOG_INIT,
"3114 Loop mode not supported\n");
diff --git a/drivers/scsi/lpfc/lpfc_init.c b/drivers/scsi/lpfc/lpfc_init.c
index 633ca46b0e4b..3defada2602f 100644
--- a/drivers/scsi/lpfc/lpfc_init.c
+++ b/drivers/scsi/lpfc/lpfc_init.c
@@ -8320,14 +8320,6 @@ lpfc_map_topology(struct lpfc_hba *phba, struct lpfc_mbx_read_config *rd_config)
phba->hba_flag |= HBA_PERSISTENT_TOPO;
switch (phba->pcidev->device) {
case PCI_DEVICE_ID_LANCER_G7_FC:
- if (tf || (pt == LINK_FLAGS_LOOP)) {
- /* Invalid values from FW - use driver params */
- phba->hba_flag &= ~HBA_PERSISTENT_TOPO;
- } else {
- /* Prism only supports PT2PT topology */
- phba->cfg_topology = FLAGS_TOPOLOGY_MODE_PT_PT;
- }
- break;
case PCI_DEVICE_ID_LANCER_G6_FC:
if (!tf) {
phba->cfg_topology = ((pt == LINK_FLAGS_LOOP)
--
2.13.7
