James,
Please review the patch below. Presuming that you lke it,
please forward upstream.
--linas
This patch adds PCI Error recovery support to the
Emulex Lightpulse Fibrechannel (lpfc) SCSI device driver.
Lightly tested at this point, works.
Signed-off-by: Linas Vepstas <linas@xxxxxxxxxxxxxx>
Cc: James Smart <james.smart@xxxxxxxxxx>
----
drivers/scsi/lpfc/lpfc_init.c | 91 ++++++++++++++++++++++++++++++++++++++++++
1 file changed, 91 insertions(+)
Index: linux-2.6.19-git7/drivers/scsi/lpfc/lpfc_init.c
===================================================================
--- linux-2.6.19-git7.orig/drivers/scsi/lpfc/lpfc_init.c 2006-12-06 13:31:39.000000000 -0600
+++ linux-2.6.19-git7/drivers/scsi/lpfc/lpfc_init.c 2006-12-06 13:33:49.000000000 -0600
@@ -517,6 +517,11 @@ lpfc_handle_eratt(struct lpfc_hba * phba
struct lpfc_sli_ring *pring;
uint32_t event_data;
+ /* If the pci channel is offline, ignore possible errors,
+ * since we cannot communicate with the pci card anyway. */
+ if (pci_channel_offline(phba->pcidev))
+ return;
+
if (phba->work_hs & HS_FFER6) {
/* Re-establishing Link */
lpfc_printf_log(phba, KERN_INFO, LOG_LINK_EVENT,
@@ -1825,6 +1830,85 @@ lpfc_pci_remove_one(struct pci_dev *pdev
pci_set_drvdata(pdev, NULL);
}
+/**
+ * lpfc_io_error_detected - called when PCI error is detected
+ * @pdev: Pointer to PCI device
+ * @state: The current pci conneection state
+ *
+ * This function is called after a PCI bus error affecting
+ * this device has been detected.
+ */
+static pci_ers_result_t lpfc_io_error_detected(struct pci_dev *pdev,
+ pci_channel_state_t state)
+{
+ if (state == pci_channel_io_perm_failure) {
+ lpfc_pci_remove_one(pdev);
+ return PCI_ERS_RESULT_DISCONNECT;
+ }
+ pci_disable_device(pdev);
+
+ /* Request a slot reset. */
+ return PCI_ERS_RESULT_NEED_RESET;
+}
+
+/**
+ * lpfc_io_slot_reset - called after the pci bus has been reset.
+ * @pdev: Pointer to PCI device
+ *
+ * Restart the card from scratch, as if from a cold-boot.
+ */
+static pci_ers_result_t lpfc_io_slot_reset(struct pci_dev *pdev)
+{
+ struct Scsi_Host *host = pci_get_drvdata(pdev);
+ struct lpfc_hba *phba = (struct lpfc_hba *)host->hostdata;
+ struct lpfc_sli *psli = &phba->sli;
+ struct lpfc_sli_ring *pring;
+
+ dev_printk(KERN_INFO, &pdev->dev, "recovering from a slot reset.\n");
+ if (pci_enable_device(pdev)) {
+ printk(KERN_ERR "lpfc: Cannot re-enable PCI device after reset.\n");
+ return PCI_ERS_RESULT_DISCONNECT;
+ }
+
+ pci_set_master(pdev);
+
+ /* Re-establishing Link */
+ spin_lock_irq(phba->host->host_lock);
+ phba->fc_flag |= FC_ESTABLISH_LINK;
+ psli->sli_flag &= ~LPFC_SLI2_ACTIVE;
+ spin_unlock_irq(phba->host->host_lock);
+
+ /*
+ * There may be I/Os dropped by the firmware.
+ * Error iocb (I/O) on txcmplq and let the SCSI layer
+ * retry it after re-establishing link.
+ */
+ pring = &psli->ring[psli->fcp_ring];
+ lpfc_sli_abort_iocb_ring(phba, pring);
+
+ /* Take device offline; this will perform cleanup */
+ lpfc_offline(phba);
+ lpfc_sli_brdrestart(phba);
+
+ return PCI_ERS_RESULT_RECOVERED;
+}
+
+/**
+ * lpfc_io_resume - called when traffic can start flowing again.
+ * @pdev: Pointer to PCI device
+ *
+ * This callback is called when the error recovery driver tells us that
+ * its OK to resume normal operation.
+ */
+static void lpfc_io_resume(struct pci_dev *pdev)
+{
+ struct Scsi_Host *host = pci_get_drvdata(pdev);
+ struct lpfc_hba *phba = (struct lpfc_hba *)host->hostdata;
+
+ lpfc_online(phba);
+ mod_timer(&phba->fc_estabtmo, jiffies + HZ * 60);
+}
+
static struct pci_device_id lpfc_id_table[] = {
{PCI_VENDOR_ID_EMULEX, PCI_DEVICE_ID_VIPER,
PCI_ANY_ID, PCI_ANY_ID, },
@@ -1885,11 +1969,18 @@ static struct pci_device_id lpfc_id_tabl
MODULE_DEVICE_TABLE(pci, lpfc_id_table);
+static struct pci_error_handlers lpfc_err_handler = {
+ .error_detected = lpfc_io_error_detected,
+ .slot_reset = lpfc_io_slot_reset,
+ .resume = lpfc_io_resume,
+};
+
static struct pci_driver lpfc_driver = {
.name = LPFC_DRIVER_NAME,
.id_table = lpfc_id_table,
.probe = lpfc_pci_probe_one,
.remove = __devexit_p(lpfc_pci_remove_one),
+ .err_handler = &lpfc_err_handler,
};
static int __init
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
