> > > > During power mode change, PACP_PWR_Req frame sends > PAPowerModeUserData > > parameters (and they are considered valid by device if Flags[4] - > > UserDataValid bit is set in the same frame). > > Currently we don't set these PAPowerModeUserData parameters and > > hardware always sets UserDataValid bit which would clear all the DL > > layer timeout values of the peer device after the power mode change. > > > > This change sets the PAPowerModeUserData[0..5] to UniPro specification > > recommended default values, in addition we are also setting the > > relevant > > DME_LOCAL_* timer attributes as required by UFS HCI specification. > > > > Signed-off-by: Can Guo <cang@xxxxxxxxxxxxxx> > Reviewed-by Avri Altman <avri.altman@xxxxxxx> BTW, I noticed that you are only updating the TC0 registers. Why not setting the TC1 registers as well? Thanks, Avri
