Couple of users had requested to print the SCSI command age along with command failure errors. This is a small change, but allows users to get more important information about the command that was failed, it would help the users in debugging the command failures: Signed-off-by: Milan P. Gandhi <mgandhi@xxxxxxxxxx> --- diff --git a/drivers/scsi/scsi_logging.c b/drivers/scsi/scsi_logging.c index ecc5918e372a..ca2182bc53c6 100644 --- a/drivers/scsi/scsi_logging.c +++ b/drivers/scsi/scsi_logging.c @@ -437,6 +437,7 @@ void scsi_print_result(const struct scsi_cmnd *cmd, const char *msg, const char *mlret_string = scsi_mlreturn_string(disposition); const char *hb_string = scsi_hostbyte_string(cmd->result); const char *db_string = scsi_driverbyte_string(cmd->result); + unsigned long cmd_age = (jiffies - cmd->jiffies_at_alloc) / HZ; logbuf = scsi_log_reserve_buffer(&logbuf_len); if (!logbuf) @@ -478,10 +479,15 @@ void scsi_print_result(const struct scsi_cmnd *cmd, const char *msg, if (db_string) off += scnprintf(logbuf + off, logbuf_len - off, - "driverbyte=%s", db_string); + "driverbyte=%s ", db_string); else off += scnprintf(logbuf + off, logbuf_len - off, - "driverbyte=0x%02x", driver_byte(cmd->result)); + "driverbyte=0x%02x ", + driver_byte(cmd->result)); + + off += scnprintf(logbuf + off, logbuf_len - off, + "cmd-age=%lus", cmd_age); + out_printk: dev_printk(KERN_INFO, &cmd->device->sdev_gendev, "%s", logbuf); scsi_log_release_buffer(logbuf);
