The qla2xxx driver had this issue as well when the newer array
firmware returned the retry_delay_timer in the fcp_rsp.
The bnx2fc is not handling the masking of the scope bits either
so the retry_delay_timestamp value lands up being a large value
added to the timer timestamp delaying I/O for up to 27 Minutes.
This patch adds similar code to handle this to the
bnx2fc driver to avoid the huge delay.
V2. Indent comments as suggested
Signed-off-by: Laurence Oberman <loberman@xxxxxxxxxx>
---
drivers/scsi/bnx2fc/bnx2fc_io.c | 23 ++++++++++++++++++++---
1 file changed, 20 insertions(+), 3 deletions(-)
diff --git a/drivers/scsi/bnx2fc/bnx2fc_io.c b/drivers/scsi/bnx2fc/bnx2fc_io.c
index 9e50e5b..39f4aeb 100644
--- a/drivers/scsi/bnx2fc/bnx2fc_io.c
+++ b/drivers/scsi/bnx2fc/bnx2fc_io.c
@@ -1928,6 +1928,7 @@ void bnx2fc_process_scsi_cmd_compl(struct bnx2fc_cmd *io_req,
struct bnx2fc_rport *tgt = io_req->tgt;
struct scsi_cmnd *sc_cmd;
struct Scsi_Host *host;
+ u16 scope, qualifier = 0;
/* scsi_cmd_cmpl is called with tgt lock held */
@@ -1997,12 +1998,28 @@ void bnx2fc_process_scsi_cmd_compl(struct bnx2fc_cmd *io_req,
if (io_req->cdb_status == SAM_STAT_TASK_SET_FULL ||
io_req->cdb_status == SAM_STAT_BUSY) {
+ /* Newer array firmware with BUSY or
+ * TASK_SET_FULL may return a status that needs
+ * the scope bits masked.
+ * Or a huge delay timestamp up to 27 minutes
+ * can result.
+ */
+ if (fcp_rsp->retry_delay_timer) {
+ /* Upper 2 bits */
+ scope = fcp_rsp->retry_delay_timer
+ & 0xC000;
+ /* Lower 14 bits */
+ qualifier = fcp_rsp->retry_delay_timer
+ & 0x3FFF;
+ }
+ if (scope > 0 && qualifier > 0 &&
+ qualifier <= 0x3FEF) {
/* Set the jiffies +
retry_delay_timer * 100ms
for the rport/tgt
*/
- tgt->retry_delay_timestamp = jiffies +
- fcp_rsp->retry_delay_timer * HZ / 10;
+ tgt->retry_delay_timestamp = jiffies +
+ (qualifier * HZ / 10);
+ }
}
-
}
if (io_req->fcp_resid)
scsi_set_resid(sc_cmd, io_req->fcp_resid);
--
1.8.3.1
