From: Xiang Chen <chenxiang66@xxxxxxxxxxxxx>
After suspend and resume, the HW registers will be set back to their
initial value. We use init_reg_v3_hw() to set some registers, but some
registers are set via firmware in ACPI "_RST" method, so add reset
handler before init_reg_v3_hw().
Signed-off-by: Xiang Chen <chenxiang66@xxxxxxxxxxxxx>
Signed-off-by: John Garry <john.garry@xxxxxxxxxx>
---
drivers/scsi/hisi_sas/hisi_sas_v3_hw.c | 10 ++++++++--
1 file changed, 8 insertions(+), 2 deletions(-)
diff --git a/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c b/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c
index 2adb5c93bd81..4c32088b9199 100644
--- a/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c
+++ b/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c
@@ -3283,15 +3283,21 @@ static int hisi_sas_v3_resume(struct pci_dev *pdev)
pci_enable_wake(pdev, PCI_D0, 0);
pci_restore_state(pdev);
rc = pci_enable_device(pdev);
- if (rc)
+ if (rc) {
dev_err(dev, "enable device failed during resume (%d)\n", rc);
+ return rc;
+ }
pci_set_master(pdev);
scsi_unblock_requests(shost);
clear_bit(HISI_SAS_REJECT_CMD_BIT, &hisi_hba->flags);
sas_prep_resume_ha(sha);
- init_reg_v3_hw(hisi_hba);
+ rc = hw_init_v3_hw(hisi_hba);
+ if (rc) {
+ scsi_remove_host(shost);
+ pci_disable_device(pdev);
+ }
hisi_hba->hw->phys_init(hisi_hba);
sas_resume_ha(sha);
clear_bit(HISI_SAS_RESET_BIT, &hisi_hba->flags);
--
2.17.1
