On 2019-02-25 17:46, Marc Gonzalez wrote:
Hello,
This series adds support for the UFS host controller on
APQ8098/MSM8998-based boards.
This should be the final rev ;-)
Tested-by: Sibi Sankar <sibis@xxxxxxxxxxxxxx>
Differences between v4 and v5:
- Drop patches that have already been accepted or spun off
Differences between v3 and v4:
- Rebase on top of -next
- Pick up Douglas Anderson's UFSHC doc fix
- Document 8998 UFSHC binding
- Improve UFS PHY binding doc
- Put the UFS DT patch at the end of the series
Difference between v2 and v3:
- Add qcom,msm8998-qmp-ufs-phy compat string and match it in the PHY
driver
- Drop vdd-hba-fixed-regulator
- Write the reg addresses with full 32-bit width
- Set regulator-allow-set-load only on the 3 rails used by UFS.
- Revert the patch introducing ufshcd_set_vccq_rail_unused
Difference between v1 and v2:
- New patch to add 'regulator-allow-set-load' prop to all vreg nodes
- Rename rpmcc node to 'clock-controller' + Add Review tags
- Drop UFS pinctrl gymnastics (not required, probably left enabled in
bootloader)
- Delete GCC_UFS_ICE_CORE_CLK (ICE not used upstream, I think)
- Fix sizes of ufsphy register areas based on Jeffrey's feedback
- Hack ufshcd_set_vccq_rail_unused into a NOP to work around lock up +
reboot
Marc Gonzalez (3):
dt-bindings: ufs: Add msm8998 compatible string
arm64: dts: qcom: msm8998: Allow UFSHC driver to set-load
arm64: dts: qcom: msm8998: Add UFS nodes
.../devicetree/bindings/ufs/ufshcd-pltfrm.txt | 1 +
arch/arm64/boot/dts/qcom/msm8998-mtp.dtsi | 22 +++++++
arch/arm64/boot/dts/qcom/msm8998.dtsi | 65 +++++++++++++++++++
3 files changed, 88 insertions(+)
--
-- Sibi Sankar --
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project.
