I am reporting an error that the scsi lun cannot initialize successfully when I am emulating megasas scsi controller with qemu. I am not sure if this is issue in qemu or linux kernel. When 'lun=1' is specified, there is "Unexpected response from lun 1 while scanning, scan aborted". Everything works well if 'lun=0' is specified. Below is the qemu cmdline involved: -device megasas,id=scsi0 \ -device scsi-hd,drive=drive0,bus=scsi0.0,lun=1 \ -drive file=/home/zhang/img/test.img,if=none,id=drive0,format=raw Below is the syslog related to 'scsi|SCSI' # dmesg | grep SCSI [ 0.392494] SCSI subsystem initialized [ 0.460666] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 251) [ 0.706788] sd 1:0:0:0: [sda] Attached SCSI disk # dmesg | grep scsi [ 0.511643] scsi host0: Avago SAS based MegaRAID driver [ 0.523302] scsi 0:2:0:0: Unexpected response from lun 1 while scanning, scan aborted [ 0.540364] scsi host1: ata_piix [ 0.540780] scsi host2: ata_piix [ 0.702396] scsi 1:0:0:0: Direct-Access ATA QEMU HARDDISK 2.5+ PQ: 0 ANSI: 5 When 'lun=1' is changed to 'lun=0', there is no issue. Thank you very much! Dongli Zhang
