On Mon, 25 Feb 2019, Marc Gonzalez wrote: > Hello, > > This series adds support for the UFS host controller on APQ8098/MSM8998-based boards. > > This should be the final rev ;-) > > Differences between v4 and v5: > - Drop patches that have already been accepted or spun off > > Differences between v3 and v4: > - Rebase on top of -next > - Pick up Douglas Anderson's UFSHC doc fix > - Document 8998 UFSHC binding > - Improve UFS PHY binding doc > - Put the UFS DT patch at the end of the series > > Difference between v2 and v3: > - Add qcom,msm8998-qmp-ufs-phy compat string and match it in the PHY driver > - Drop vdd-hba-fixed-regulator > - Write the reg addresses with full 32-bit width > - Set regulator-allow-set-load only on the 3 rails used by UFS. > - Revert the patch introducing ufshcd_set_vccq_rail_unused > > Difference between v1 and v2: > - New patch to add 'regulator-allow-set-load' prop to all vreg nodes > - Rename rpmcc node to 'clock-controller' + Add Review tags > - Drop UFS pinctrl gymnastics (not required, probably left enabled in bootloader) > - Delete GCC_UFS_ICE_CORE_CLK (ICE not used upstream, I think) > - Fix sizes of ufsphy register areas based on Jeffrey's feedback > - Hack ufshcd_set_vccq_rail_unused into a NOP to work around lock up + reboot > > > Marc Gonzalez (3): > dt-bindings: ufs: Add msm8998 compatible string > arm64: dts: qcom: msm8998: Allow UFSHC driver to set-load > arm64: dts: qcom: msm8998: Add UFS nodes > > .../devicetree/bindings/ufs/ufshcd-pltfrm.txt | 1 + > arch/arm64/boot/dts/qcom/msm8998-mtp.dtsi | 22 +++++++ > arch/arm64/boot/dts/qcom/msm8998.dtsi | 65 +++++++++++++++++++ > 3 files changed, 88 insertions(+) I assume these are the same patches we've been using in our tree. If so: Tested-by: Lee Jones <lee.jones@xxxxxxxxxx> -- Lee Jones [李琼斯] Linaro Services Technical Lead Linaro.org │ Open source software for ARM SoCs Follow Linaro: Facebook | Twitter | Blog
