John,
> +static void fill_prot_v3_hw(struct scsi_cmnd *scsi_cmnd,
> + struct hisi_sas_protect_iu_v3_hw *prot)
> +{
> + u8 prot_type = scsi_get_prot_type(scsi_cmnd);
> + u8 prot_op = scsi_get_prot_op(scsi_cmnd);
> + unsigned int interval = scsi_prot_interval(scsi_cmnd);
> + u32 lbrt_chk_val;
> +
> + if (interval == 4096)
> + lbrt_chk_val = (u32)(scsi_get_lba(scsi_cmnd) >> 3);
> + else
> + lbrt_chk_val = (u32)scsi_get_lba(scsi_cmnd);
lbrt_chk_val = t10_pi_ref_tag(scmd->request);
> +
> + switch (prot_op) {
> + case SCSI_PROT_READ_STRIP:
> + prot->dw0 |= (T10_RMV_EN_MSK | T10_CHK_EN_MSK);
> + prot->lbrtcv = lbrt_chk_val;
> + if (prot_type == SCSI_PROT_DIF_TYPE1)
> + prot->dw4 |= (0xc << 16);
> + else if (prot_type == SCSI_PROT_DIF_TYPE3)
> + prot->dw4 |= (0xfc << 16);
We're moving away from prot_type. You should use:
enum scsi_prot_flags {
SCSI_PROT_TRANSFER_PI = 1 << 0,
SCSI_PROT_GUARD_CHECK = 1 << 1,
SCSI_PROT_REF_CHECK = 1 << 2,
SCSI_PROT_REF_INCREMENT = 1 << 3,
SCSI_PROT_IP_CHECKSUM = 1 << 4,
};
to set your controller flags.
+ if (prot_op == SCSI_PROT_WRITE_INSERT) {
+ unsigned int interval = scsi_prot_interval(scsi_cmnd);
+ unsigned int ilog2_interval = ilog2(interval);
+
+ len = (task->total_xfer_len >> ilog2_interval) * 8;
scsi_transfer_length(struct scsi_cmnd *scmd)
> + if (hisi_hba->enable_dif) {
> + dev_info(dev, "Registering for DIF type 1/2/3 protection.\n");
> + prot |= SHOST_DIF_TYPE1_PROTECTION |
> + SHOST_DIF_TYPE2_PROTECTION |
> + SHOST_DIF_TYPE3_PROTECTION;
> + }
> +
> + scsi_host_set_prot(hisi_hba->shost, prot);
I'm not so keen on this enable_dif/enable_dix business in module
parameters. I suggest you just allow the user to specify the host
protection mask instead of having a layer of indirection.
--
Martin K. Petersen Oracle Linux Engineering
