Re: [PATCH v3] scsi: ufs: Make sysfs attributes writable

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, Aug 8, 2018 at 1:47 AM Stanislav Nijnikov
<Stanislav.Nijnikov@xxxxxxx> wrote:
>
> Hi Evan,
>
> > -----Original Message-----
> > From: Evan Green <evgreen@xxxxxxxxxxxx>
> > Sent: Tuesday, August 7, 2018 9:15 PM
> > To: Stanislav Nijnikov <Stanislav.Nijnikov@xxxxxxx>
> > Cc: Vinayak Holikatti <vinholikatti@xxxxxxxxx>; jejb@xxxxxxxxxxxxxxxxxx; martin.petersen@xxxxxxxxxx; adrian.hunter@xxxxxxxxx;
> > linux-kernel@xxxxxxxxxxxxxxx; linux-scsi@xxxxxxxxxxxxxxx; Bart Van Assche <Bart.VanAssche@xxxxxxx>
> > Subject: Re: [PATCH v3] scsi: ufs: Make sysfs attributes writable
> >
> > Hi Stanislav. Thanks for the review.
> >
> > On Mon, Aug 6, 2018 at 2:28 AM Stanislav Nijnikov
> > <Stanislav.Nijnikov@xxxxxxx> wrote:
> > >
> > > Hi Evan,
> > >
> > > > -----Original Message-----
> > > > From: Evan Green <evgreen@xxxxxxxxxxxx>
> > > > Sent: Wednesday, July 25, 2018 11:15 PM
> > > > To: Vinayak Holikatti <vinholikatti@xxxxxxxxx>; James E.J. Bottomley <jejb@xxxxxxxxxxxxxxxxxx>; Martin K. Petersen
> > > > <martin.petersen@xxxxxxxxxx>; Stanislav Nijnikov <Stanislav.Nijnikov@xxxxxxx>; Adrian Hunter <adrian.hunter@xxxxxxxxx>;
> > linux-
> > > > kernel@xxxxxxxxxxxxxxx; linux-scsi@xxxxxxxxxxxxxxx; Bart Van Assche <Bart.VanAssche@xxxxxxx>
> > > > Cc: Evan Green <evgreen@xxxxxxxxxxxx>
> > > > Subject: [PATCH v3] scsi: ufs: Make sysfs attributes writable
> > > >
> > > > This change makes the UFS controller's sysfs attributes writable, which
> > > > will enable users to modify attributes. This can be useful during factory
> > > > provisioning for setting up critical attributes like the reference clock
> > > > frequency.
> > > >
> > > > Signed-off-by: Evan Green <evgreen@xxxxxxxxxxxx>
> > > > ---
> > > > Configfs was determined to be the preferred mechanism for writing the
> > > > config descriptor, but attributes also need to be written during setup,
> > > > and are already present in sysfs. Making these attributes writable is
> > > > also helpful for debugging and experimentation.
> > > >
> > > > Changes since v2:
> > > >       - Removed the configuration descriptor changes from the series,
> > > > since configfs was the preferred way to write to that, leaving only
> > > > this change.
> > > >
> > > > Changes since v1:
> > > >       - Reworked the interface to show each unit of the config
> > > > descriptor as a separate directory, rather than the previous method I
> > > > had of a file for selecting the unit, and then a common set of files
> > > > that interacted with whichever unit was selected. I did some kobject
> > > > magic to accomplish this. I noticed from Greg KH's reply to Sayali's
> > > > patches [1] that configfs might be the preferred method. Let me know
> > > > if I should abandon this series in favor of Sayali's, with the
> > > > possible exception of "Make sysfs attributes writable".
> > > >       - Squashed documentation changes into their respective code
> > > > changes.
> > > >       - I decided to keep the config descriptor attributes as their
> > > > own files, rather than hiding writes behind device descriptor and unit
> > > > descriptor, as I think that's more future proof and true to the UFS spec.
> > > >
> > > > [1] https://lkml.org/lkml/2018/6/8/210
> > > >
> > > >  Documentation/ABI/testing/sysfs-driver-ufs | 17 +--------
> > > >  drivers/scsi/ufs/ufs-sysfs.c               | 58 ++++++++++++++++++++----------
> > > >  2 files changed, 40 insertions(+), 35 deletions(-)
> > > >
> > ...
> > > > diff --git a/drivers/scsi/ufs/ufs-sysfs.c b/drivers/scsi/ufs/ufs-sysfs.c
> > > > index 8d9332bb7d0c..5e286b9d1aea 100644
> > > > --- a/drivers/scsi/ufs/ufs-sysfs.c
> > > > +++ b/drivers/scsi/ufs/ufs-sysfs.c
> > > > @@ -655,7 +655,7 @@ static const struct attribute_group ufs_sysfs_flags_group = {
> > > >       .attrs = ufs_sysfs_device_flags,
> > > >  };
> > > >
> > > > -#define UFS_ATTRIBUTE(_name, _uname)                                 \
> > > > +#define UFS_ATTRIBUTE_SHOW(_name, _uname)                            \
> > > >  static ssize_t _name##_show(struct device *dev,                              \
> > > >       struct device_attribute *attr, char *buf)                       \
> > > >  {                                                                    \
> > > > @@ -665,25 +665,45 @@ static ssize_t _name##_show(struct device *dev,                         \
> > > >               QUERY_ATTR_IDN##_uname, 0, 0, &value))                  \
> > > >               return -EINVAL;                                         \
> > > >       return sprintf(buf, "0x%08X\n", value);                         \
> > > > -}                                                                    \
> > > > -static DEVICE_ATTR_RO(_name)
> > > > +}
> > > >
> > > > -UFS_ATTRIBUTE(boot_lun_enabled, _BOOT_LU_EN);
> > > > -UFS_ATTRIBUTE(current_power_mode, _POWER_MODE);
> > > > -UFS_ATTRIBUTE(active_icc_level, _ACTIVE_ICC_LVL);
> > > > -UFS_ATTRIBUTE(ooo_data_enabled, _OOO_DATA_EN);
> > > > -UFS_ATTRIBUTE(bkops_status, _BKOPS_STATUS);
> > > > -UFS_ATTRIBUTE(purge_status, _PURGE_STATUS);
> > > > -UFS_ATTRIBUTE(max_data_in_size, _MAX_DATA_IN);
> > > > -UFS_ATTRIBUTE(max_data_out_size, _MAX_DATA_OUT);
> > > > -UFS_ATTRIBUTE(reference_clock_frequency, _REF_CLK_FREQ);
> > > > -UFS_ATTRIBUTE(configuration_descriptor_lock, _CONF_DESC_LOCK);
> > > > -UFS_ATTRIBUTE(max_number_of_rtt, _MAX_NUM_OF_RTT);
> > > > -UFS_ATTRIBUTE(exception_event_control, _EE_CONTROL);
> > > > -UFS_ATTRIBUTE(exception_event_status, _EE_STATUS);
> > > > -UFS_ATTRIBUTE(ffu_status, _FFU_STATUS);
> > > > -UFS_ATTRIBUTE(psa_state, _PSA_STATE);
> > > > -UFS_ATTRIBUTE(psa_data_size, _PSA_DATA_SIZE);
> > > > +#define UFS_ATTRIBUTE_RO(_name, _uname)                                      \
> > > > +UFS_ATTRIBUTE_SHOW(_name, _uname)                                    \
> > > > +DEVICE_ATTR_RO(_name)
> > > It should be static here.
> >
> > Will fix.
> >
> > >
> > > > +
> > > > +#define UFS_ATTRIBUTE_RW(_name, _uname)                                      \
> > > > +UFS_ATTRIBUTE_SHOW(_name, _uname)                                    \
> > > > +static ssize_t _name##_store(struct device *dev,                     \
> > > > +             struct device_attribute *attr, const char *buf,         \
> > > > +             size_t count)                                           \
> > > > +{                                                                    \
> > > > +     struct ufs_hba *hba = dev_get_drvdata(dev);                     \
> > > > +     u32 value;                                                      \
> > > > +     if (kstrtou32(buf, 0, &value))                                  \
> > > > +             return -EINVAL;                                         \
> > > > +     if (ufshcd_query_attr(hba, UPIU_QUERY_OPCODE_WRITE_ATTR,        \
> > > > +             QUERY_ATTR_IDN##_uname, 0, 0, &value))                  \
> > > > +             return -EINVAL;                                         \
> > > > +     return count;                                                   \
> > > > +}                                                                    \
> > > > +static DEVICE_ATTR_RW(_name)
> > > > +
> > > > +UFS_ATTRIBUTE_RW(boot_lun_enabled, _BOOT_LU_EN);
> > > > +UFS_ATTRIBUTE_RO(current_power_mode, _POWER_MODE);
> > > > +UFS_ATTRIBUTE_RW(active_icc_level, _ACTIVE_ICC_LVL);
> > > > +UFS_ATTRIBUTE_RW(ooo_data_enabled, _OOO_DATA_EN);
> > > I would prefer to leave "write once" attributes as read-only.
> >
> > Oh, but I want those write once attributes, I plan to use them during
> > provisioning. Are you worried about accidental writes? My mind jumps
> > to some sort of unlock mechanism where you write a magic string into
> > an additional sysfs file to unlock the write-once attributes. But the
> > last time I proposed a sysfs file that affected the behavior of other
> > sysfs files, I got the proverbial raspberry. Any thoughts?
> >
> Well, I suppose users with root  permissions should know what they are
> doing. At least, add a special comment for these in the ABI file, not
> everyone has access to the UFS spec.

Will do. Spin coming up.
-Evan



[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Index of Archives]     [SCSI Target Devel]     [Linux SCSI Target Infrastructure]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Linux IIO]     [Samba]     [Device Mapper]

  Powered by Linux