From: Xiaofei Tan <tanxiaofei@xxxxxxxxxx> Much code of PM suspend function also exists in soft reset function. This is not concise. So, this patch relocates the common code of these two functions to a separate function. Signed-off-by: Xiaofei Tan <tanxiaofei@xxxxxxxxxx> Signed-off-by: John Garry <john.garry@xxxxxxxxxx> --- drivers/scsi/hisi_sas/hisi_sas_v3_hw.c | 50 ++++++++++++++++++---------------- 1 file changed, 27 insertions(+), 23 deletions(-) diff --git a/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c b/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c index 70a6aa2..3577843 100644 --- a/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c +++ b/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c @@ -210,6 +210,8 @@ #define AXI_MASTER_CFG_BASE (0x5000) #define AM_CTRL_GLOBAL (0x0) +#define AM_CTRL_SHUTDOWN_REQ_OFF 0 +#define AM_CTRL_SHUTDOWN_REQ_MSK (0x1 << AM_CTRL_SHUTDOWN_REQ_OFF) #define AM_CURR_TRANS_RETURN (0x150) #define AM_CFG_MAX_TRANS (0x5010) @@ -1976,11 +1978,11 @@ static void phy_get_events_v3_hw(struct hisi_hba *hisi_hba, int phy_no) } -static int soft_reset_v3_hw(struct hisi_hba *hisi_hba) +static int disable_host_v3_hw(struct hisi_hba *hisi_hba) { struct device *dev = hisi_hba->dev; + u32 status, reg_val; int rc; - u32 status; interrupt_disable_v3_hw(hisi_hba); hisi_sas_write32(hisi_hba, DLVRY_QUEUE_ENABLE, 0x0); @@ -1990,14 +1992,32 @@ static int soft_reset_v3_hw(struct hisi_hba *hisi_hba) mdelay(10); - hisi_sas_write32(hisi_hba, AXI_MASTER_CFG_BASE + AM_CTRL_GLOBAL, 0x1); + reg_val = hisi_sas_read32(hisi_hba, AXI_MASTER_CFG_BASE + + AM_CTRL_GLOBAL); + reg_val |= AM_CTRL_SHUTDOWN_REQ_MSK; + hisi_sas_write32(hisi_hba, AXI_MASTER_CFG_BASE + + AM_CTRL_GLOBAL, reg_val); /* wait until bus idle */ rc = hisi_sas_read32_poll_timeout(AXI_MASTER_CFG_BASE + AM_CURR_TRANS_RETURN, status, status == 0x3, 10, 100); if (rc) { - dev_err(dev, "axi bus is not idle, rc = %d\n", rc); + dev_err(dev, "axi bus is not idle, rc=%d\n", rc); + return rc; + } + + return 0; +} + +static int soft_reset_v3_hw(struct hisi_hba *hisi_hba) +{ + struct device *dev = hisi_hba->dev; + int rc; + + rc = disable_host_v3_hw(hisi_hba); + if (rc) { + dev_err(dev, "soft reset: disable host failed rc=%d\n", rc); return rc; } @@ -2456,9 +2476,8 @@ static int hisi_sas_v3_suspend(struct pci_dev *pdev, pm_message_t state) struct hisi_hba *hisi_hba = sha->lldd_ha; struct device *dev = hisi_hba->dev; struct Scsi_Host *shost = hisi_hba->shost; - u32 device_state, status; + u32 device_state; int rc; - u32 reg_val; if (!pdev->pm_cap) { dev_err(dev, "PCI PM not supported\n"); @@ -2471,25 +2490,10 @@ static int hisi_sas_v3_suspend(struct pci_dev *pdev, pm_message_t state) scsi_block_requests(shost); set_bit(HISI_SAS_REJECT_CMD_BIT, &hisi_hba->flags); flush_workqueue(hisi_hba->wq); - /* disable DQ/PHY/bus */ - interrupt_disable_v3_hw(hisi_hba); - hisi_sas_write32(hisi_hba, DLVRY_QUEUE_ENABLE, 0x0); - hisi_sas_kill_tasklets(hisi_hba); - hisi_sas_stop_phys(hisi_hba); - - reg_val = hisi_sas_read32(hisi_hba, AXI_MASTER_CFG_BASE + - AM_CTRL_GLOBAL); - reg_val |= 0x1; - hisi_sas_write32(hisi_hba, AXI_MASTER_CFG_BASE + - AM_CTRL_GLOBAL, reg_val); - - /* wait until bus idle */ - rc = hisi_sas_read32_poll_timeout(AXI_MASTER_CFG_BASE + - AM_CURR_TRANS_RETURN, status, - status == 0x3, 10, 100); + rc = disable_host_v3_hw(hisi_hba); if (rc) { - dev_err(dev, "axi bus is not idle, rc = %d\n", rc); + dev_err(dev, "PM suspend: disable host failed rc=%d\n", rc); clear_bit(HISI_SAS_REJECT_CMD_BIT, &hisi_hba->flags); clear_bit(HISI_SAS_RESET_BIT, &hisi_hba->flags); scsi_unblock_requests(shost); -- 1.9.1