On Fri, Jun 08, 2018 at 04:36:28PM +0530, Sayali Lokhande wrote: > From: Subhash Jadavani <subhashj@xxxxxxxxxxxxxx> > > UFS host supplies the reference clock to UFS device and UFS device > specification allows host to provide one of the 4 frequencies (19.2 MHz, > 26 MHz, 38.4 MHz, 52 MHz) for reference clock. Host should set the > device reference clock frequency setting in the device based on what > frequency it is supplying to UFS device. > > Signed-off-by: Subhash Jadavani <subhashj@xxxxxxxxxxxxxx> > Signed-off-by: Can Guo <cang@xxxxxxxxxxxxxx> > Signed-off-by: Sayali Lokhande <sayalil@xxxxxxxxxxxxxx> > --- > .../devicetree/bindings/ufs/ufshcd-pltfrm.txt | 7 +++ > drivers/scsi/ufs/ufs.h | 9 ++++ > drivers/scsi/ufs/ufshcd-pltfrm.c | 24 ++++++++++ > drivers/scsi/ufs/ufshcd.c | 52 ++++++++++++++++++++++ > drivers/scsi/ufs/ufshcd.h | 1 + > 5 files changed, 93 insertions(+) > > diff --git a/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt b/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt > index c39dfef..4522434 100644 > --- a/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt > +++ b/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt > @@ -41,6 +41,12 @@ Optional properties: > -lanes-per-direction : number of lanes available per direction - either 1 or 2. > Note that it is assume same number of lanes is used both > directions at once. If not specified, default is 2 lanes per direction. > +- dev-ref-clk-freq : Specify the device reference clock frequency, must be one of the following: > + 0: 19.2 MHz > + 1: 26 MHz > + 2: 38.4 MHz > + 3: 52 MHz > + Defaults to 26 MHz if not specified. I must have misunderstood your last response. I thought you could handle things without DT. If not, my question remains. Rob
