Hi Rob, For UFS provisioning, all we need is ref_clk to be set to 19.2MHz before actual descriptor write happens. So I can actually avoid parsing it via DT and use REF_CLK_FREQ_19_2_MHZ from enum ref_clk_freq (which is already added in my current implementation). Thanks, Sayali -----Original Message----- From: Rob Herring [mailto:robh@xxxxxxxxxx] Sent: Thursday, May 24, 2018 12:19 AM To: Sayali Lokhande <sayalil@xxxxxxxxxxxxxx> Cc: subhashj@xxxxxxxxxxxxxx; cang@xxxxxxxxxxxxxx; vivek.gautam@xxxxxxxxxxxxxx; rnayak@xxxxxxxxxxxxxx; vinholikatti@xxxxxxxxx; jejb@xxxxxxxxxxxxxxxxxx; martin.petersen@xxxxxxxxxx; asutoshd@xxxxxxxxxxxxxx; linux-scsi@xxxxxxxxxxxxxxx; Mark Rutland <mark.rutland@xxxxxxx>; Mathieu Malaterre <malat@xxxxxxxxxx>; open list:OPEN FIRMWARE AND FLATTENED DEVICE TREE BINDINGS <devicetree@xxxxxxxxxxxxxxx>; open list <linux-kernel@xxxxxxxxxxxxxxx> Subject: Re: [PATCH RFC 1/3] scsi: ufs: set the device reference clock setting On Tue, May 22, 2018 at 09:51:38AM +0530, Sayali Lokhande wrote: > From: Subhash Jadavani <subhashj@xxxxxxxxxxxxxx> > > UFS host supplies the reference clock to UFS device and UFS device > specification allows host to provide one of the 4 frequencies (19.2 > MHz, > 26 MHz, 38.4 MHz, 52 MHz) for reference clock. Host should set the > device reference clock frequency setting in the device based on what > frequency it is supplying to UFS device. > > Signed-off-by: Subhash Jadavani <subhashj@xxxxxxxxxxxxxx> > [cang@xxxxxxxxxxxxxx: Resolved trivial merge conflicts] > Signed-off-by: Can Guo <cang@xxxxxxxxxxxxxx> > Signed-off-by: Sayali Lokhande <sayalil@xxxxxxxxxxxxxx> > --- > .../devicetree/bindings/ufs/ufshcd-pltfrm.txt | 8 +++ > drivers/scsi/ufs/ufs.h | 9 ++++ > drivers/scsi/ufs/ufshcd-pltfrm.c | 20 ++++++++ > drivers/scsi/ufs/ufshcd.c | 60 ++++++++++++++++++++++ > drivers/scsi/ufs/ufshcd.h | 2 + > 5 files changed, 99 insertions(+) > > diff --git a/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt > b/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt > index c39dfef..ac94220 100644 > --- a/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt > +++ b/Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt > @@ -41,6 +41,12 @@ Optional properties: > -lanes-per-direction : number of lanes available per direction - either 1 or 2. > Note that it is assume same number of lanes is used both > directions at once. If not specified, default is 2 lanes per direction. > +- dev-ref-clk-freq : Specify the device reference clock frequency, must be one of the following: > + 0: 19.2 MHz > + 1: 26 MHz > + 2: 38.4 MHz > + 3: 52 MHz > + Defaults to 26 MHz if not specified. You already have "ref_clk", can't you just read its frequency? Rob
