If the read-only flag is true on a SCSI disk, re-reading the partition
table sets the flag back to false.
To observe this bug, you can run:
1. blockdev --setro /dev/sda
2. blockdev --rereadpt /dev/sda
3. blockdev --getro /dev/sda
This commit reads the disk's old state and combines it with the device
disk-reported state rather than unconditionally marking it as RW.
Reported-by: Li Ning <lining916740672@xxxxxxxxxx>
Signed-off-by: Jeremy Cline <jeremy@xxxxxxxxxx>
---
drivers/scsi/sd.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/scsi/sd.c b/drivers/scsi/sd.c
index bff21e636ddd..7a3a66a7890f 100644
--- a/drivers/scsi/sd.c
+++ b/drivers/scsi/sd.c
@@ -2595,6 +2595,7 @@ sd_read_write_protect_flag(struct scsi_disk *sdkp, unsigned char *buffer)
int res;
struct scsi_device *sdp = sdkp->device;
struct scsi_mode_data data;
+ int disk_ro = get_disk_ro(sdkp->disk);
int old_wp = sdkp->write_prot;
set_disk_ro(sdkp->disk, 0);
@@ -2634,7 +2635,8 @@ sd_read_write_protect_flag(struct scsi_disk *sdkp, unsigned char *buffer)
sd_first_printk(KERN_WARNING, sdkp,
"Test WP failed, assume Write Enabled\n");
} else {
- sdkp->write_prot = ((data.device_specific & 0x80) != 0);
+ sdkp->write_prot = ((data.device_specific & 0x80) != 0) ||
+ disk_ro;
set_disk_ro(sdkp->disk, sdkp->write_prot);
if (sdkp->first_scan || old_wp != sdkp->write_prot) {
sd_printk(KERN_NOTICE, sdkp, "Write Protect is %s\n",
--
2.16.2
