On Thursday 12 October 2017 11:49 AM, Vivek Gautam wrote: > Refactoring the qcom-ufs phy and host controller code to move > further towards the generic phy usage. Right now the qcom-ufs exports > a bunch of APIs that are used by the host controller to initialize > the phy. > With this patch series, we populate the phy_init() which was a no-op > earlier. The host controller then calls the phy_init() at the designated > place rather than doing it invariably in ufs_hcd_init(). > > As part of this series, we introduce phy modes for ufs phy. > The M-PHY has two data rates defined for each generations (Gears) - > Rate A and Rate B. These can serve as the two modes of ufs HS phy. > Host controller can direct the phy to set the respective configurations > based on the phy modes. > > The patch-series has been tested with necessary dt patches on db820c. > > > Hi Kishon, > > I shall be on vacation for the next week. Can you kindly consider > picking this series for 4.15. Martin was good with last version > of the patches[1], and Subhash has reviewed the patches of which > he has given 'Reviewed-by' for [PATCH 4/5] , and I have addressed > his comments for the last patch. I hope it's not too late for 4.15. > Subhash, can you please consider giving your 'Reviewed-by' for > the last patch if you find it good. merged to phy -next, thanks! -Kishon > > [1] https://lkml.org/lkml/2017/8/10/958 > > Vivek Gautam (5): > dt-bindings: phy: Add PHY_TYPE_UFS definition > phy: Add UFS PHY modes > phy: qcom-ufs: Add support to set phy mode > scsi/ufs: qcom: Set phy mode based on the controllers HS MODE > ufs/phy: qcom: Refactor to use phy_init call > > drivers/phy/qualcomm/phy-qcom-ufs-i.h | 5 ++-- > drivers/phy/qualcomm/phy-qcom-ufs-qmp-14nm.c | 29 +++++++++++++++++-- > drivers/phy/qualcomm/phy-qcom-ufs-qmp-20nm.c | 29 +++++++++++++++++-- > drivers/phy/qualcomm/phy-qcom-ufs.c | 42 ++++++++++------------------ > drivers/scsi/ufs/ufs-qcom.c | 39 +++++++++++--------------- > include/dt-bindings/phy/phy.h | 1 + > include/linux/phy/phy-qcom-ufs.h | 3 -- > include/linux/phy/phy.h | 2 ++ > 8 files changed, 91 insertions(+), 59 deletions(-) >