Different SAS addresses are assigned for each set of phys.
Signed-off-by: Viswas G <Viswas.G@xxxxxxxxxxxxx>
---
drivers/scsi/pm8001/pm8001_init.c | 13 +++++++++----
drivers/scsi/pm8001/pm80xx_hwi.c | 3 +--
2 files changed, 10 insertions(+), 6 deletions(-)
diff --git a/drivers/scsi/pm8001/pm8001_init.c b/drivers/scsi/pm8001/pm8001_init.c
index 034b2f7d1135..d282f1562615 100644
--- a/drivers/scsi/pm8001/pm8001_init.c
+++ b/drivers/scsi/pm8001/pm8001_init.c
@@ -132,7 +132,7 @@ static void pm8001_phy_init(struct pm8001_hba_info *pm8001_ha, int phy_id)
sas_phy->oob_mode = OOB_NOT_CONNECTED;
sas_phy->linkrate = SAS_LINK_RATE_UNKNOWN;
sas_phy->id = phy_id;
- sas_phy->sas_addr = &pm8001_ha->sas_addr[0];
+ sas_phy->sas_addr = (u8 *)&phy->dev_sas_addr;
sas_phy->frame_rcvd = &phy->frame_rcvd[0];
sas_phy->ha = (struct sas_ha_struct *)pm8001_ha->shost->hostdata;
sas_phy->lldd_phy = phy;
@@ -593,10 +593,12 @@ static void pm8001_post_sas_ha_init(struct Scsi_Host *shost,
for (i = 0; i < chip_info->n_phy; i++) {
sha->sas_phy[i] = &pm8001_ha->phy[i].sas_phy;
sha->sas_port[i] = &pm8001_ha->port[i].sas_port;
+ sha->sas_phy[i]->sas_addr =
+ (u8 *)&pm8001_ha->phy[i].dev_sas_addr;
}
sha->sas_ha_name = DRV_NAME;
sha->dev = pm8001_ha->dev;
-
+ sha->strict_wide_ports = 1;
sha->lldd_module = THIS_MODULE;
sha->sas_addr = &pm8001_ha->sas_addr[0];
sha->num_phys = chip_info->n_phy;
@@ -613,6 +615,7 @@ static void pm8001_post_sas_ha_init(struct Scsi_Host *shost,
static void pm8001_init_sas_add(struct pm8001_hba_info *pm8001_ha)
{
u8 i, j;
+ u8 sas_add[8];
#ifdef PM8001_READ_VPD
/* For new SPC controllers WWN is stored in flash vpd
* For SPC/SPCve controllers WWN is stored in EEPROM
@@ -674,10 +677,12 @@ static void pm8001_init_sas_add(struct pm8001_hba_info *pm8001_ha)
pm8001_ha->sas_addr[j] =
payload.func_specific[0x804 + i];
}
-
+ memcpy(sas_add, pm8001_ha->sas_addr, SAS_ADDR_SIZE);
for (i = 0; i < pm8001_ha->chip->n_phy; i++) {
+ if (i && ((i % 4) == 0))
+ sas_add[7] = sas_add[7] + 4;
memcpy(&pm8001_ha->phy[i].dev_sas_addr,
- pm8001_ha->sas_addr, SAS_ADDR_SIZE);
+ sas_add, SAS_ADDR_SIZE);
PM8001_INIT_DBG(pm8001_ha,
pm8001_printk("phy %d sas_addr = %016llx\n", i,
pm8001_ha->phy[i].dev_sas_addr));
diff --git a/drivers/scsi/pm8001/pm80xx_hwi.c b/drivers/scsi/pm8001/pm80xx_hwi.c
index 8fb5ddf08cc4..a07b023c09bf 100644
--- a/drivers/scsi/pm8001/pm80xx_hwi.c
+++ b/drivers/scsi/pm8001/pm80xx_hwi.c
@@ -3041,7 +3041,6 @@ hw_event_phy_down(struct pm8001_hba_info *pm8001_ha, void *piomb)
port->port_state = portstate;
phy->identify.device_type = 0;
phy->phy_attached = 0;
- memset(&phy->dev_sas_addr, 0, SAS_ADDR_SIZE);
switch (portstate) {
case PORT_VALID:
break;
@@ -4394,7 +4393,7 @@ pm80xx_chip_phy_start_req(struct pm8001_hba_info *pm8001_ha, u8 phy_id)
payload.sas_identify.dev_type = SAS_END_DEVICE;
payload.sas_identify.initiator_bits = SAS_PROTOCOL_ALL;
memcpy(payload.sas_identify.sas_addr,
- pm8001_ha->sas_addr, SAS_ADDR_SIZE);
+ &pm8001_ha->phy[phy_id].dev_sas_addr, SAS_ADDR_SIZE);
payload.sas_identify.phy_id = phy_id;
ret = pm8001_mpi_build_cmd(pm8001_ha, circularQ, opcode, &payload, 0);
return ret;
--
2.12.3
