在 2017/6/23 9:05, Subhash Jadavani 写道:
On 2017-06-22 04:51, Arnd Bergmann wrote:
On Thu, Jun 22, 2017 at 1:44 PM, Bu Tao <butao@xxxxxxxxxx> wrote:
在 2017/6/17 5:51, Arnd Bergmann 写道:
On Fri, Jun 16, 2017 at 8:51 AM, Bu Tao <butao@xxxxxxxxxxxxx> wrote:
+Optional properties for board device:
+- ufs-hi3660-use-rate-B : specifies UFS rate-B
+- ufs-hi3660-broken-fastauto : specifies no fastauto
+- ufs-hi3660-use-HS-GEAR3 : specifies UFS HS-GEAR3
+- ufs-hi3660-use-HS-GEAR2 : specifies UFS HS-GEAR2
+- ufs-hi3660-use-HS-GEAR1 : specifies UFS HS-GEAR1
+- ufs-hi3660-broken-clk-gate-bypass : specifies no clk-gate
+- ufs-hi3660-use-one-line : specifies UFS use one line work
+- reset-gpio : specifies to reset devices
Some of these sound rather generic and might apply to UFS
implementations
other than hi3660, so I'd suggest adding them to the base ufs
binding with
a generic name instead.
Any DT properties that might be useful across multiple implementations
should be parsed in generic code that gets called by the individual
drivers,
and then the properties that are specific to the integration work
done by
hisilicon should be prefixed with "hisilicon,", but not normally
with the
SoC name: it is quite possible that another SoC will be derived from
this
chip and it should reuse the properties.
I do not know wheher other SoC need to use the optional properties as
abover. So here the name of the optional properties has "hi3660".
They should not have "hi3660" in their names either way, independent
of where they are used.
Yes, i agree with Arnd that SoCs might also need these so please make
these properties generic (put them under
Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt) and also move
their parsing code in generic driver (ufshcd.c or ufshcd-pltfrm.c).
Thanks for your comments. I will modify this and update soon.
(note: this is different from the value of the "compatible" property
that
is meant to be as specific as possible".
Also, please clarify how your binding relates to the ufshcd binding
in Documentation/devicetree/bindings/ufs/ufshcd-pltfrm.txt: does
hi3660 implement any registers that are shared with ufshcd, or does
it use the same physical interface with a different register set?
No, only show how to use the dt-binding for hi3660 SoC
My question was about the hardware: does hi3660 implement ufshcd
or not?
Arnd
