The default queue depth for non NATIVE RAW disks is calculated from the
number of fibs and number of disks or a max of 256. This causes poor disk
IO performance.
The fix is to set default qd based on the type of disks
(SATA -32 and SAS -64)
Signed-off-by: Raghava Aditya Renukunta <RaghavaAditya.Renukunta@xxxxxxxxxxxxx>
Reviewed-by: David Carroll <david.carroll@xxxxxxxxxxxxx>
--
Changes in V2:
None
-
drivers/scsi/aacraid/linit.c | 28 ++++++++++++++++++++--------
1 file changed, 20 insertions(+), 8 deletions(-)
diff --git a/drivers/scsi/aacraid/linit.c b/drivers/scsi/aacraid/linit.c
index 5e1a2d6..9ef98e4 100644
--- a/drivers/scsi/aacraid/linit.c
+++ b/drivers/scsi/aacraid/linit.c
@@ -405,17 +405,23 @@ static int aac_slave_configure(struct scsi_device *sdev)
int chn, tid;
unsigned int depth = 0;
unsigned int set_timeout = 0;
+ bool set_qd_dev_type = false;
+ u8 devtype = 0;
chn = aac_logical_to_phys(sdev_channel(sdev));
tid = sdev_id(sdev);
- if (chn < AAC_MAX_BUSES && tid < AAC_MAX_TARGETS &&
- aac->hba_map[chn][tid].devtype == AAC_DEVTYPE_NATIVE_RAW) {
- depth = aac->hba_map[chn][tid].qd_limit;
+ if (chn < AAC_MAX_BUSES && tid < AAC_MAX_TARGETS && aac->sa_firmware) {
+ devtype = aac->hba_map[chn][tid].devtype;
+
+ if (devtype == AAC_DEVTYPE_NATIVE_RAW)
+ depth = aac->hba_map[chn][tid].qd_limit;
+ else if (devtype == AAC_DEVTYPE_ARC_RAW)
+ set_qd_dev_type = true;
+
set_timeout = 1;
goto common_config;
}
-
if (aac->jbod && (sdev->type == TYPE_DISK))
sdev->removable = 1;
@@ -470,16 +476,22 @@ static int aac_slave_configure(struct scsi_device *sdev)
if (sdev_channel(sdev) != NATIVE_CHANNEL)
goto common_config;
- /*
- * Check if SATA drive
- */
+ set_qd_dev_type = true;
+
+ }
+
+common_config:
+
+ /*
+ * Check if SATA drive
+ */
+ if (set_qd_dev_type) {
if (strncmp(sdev->vendor, "ATA", 3) == 0)
depth = 32;
else
depth = 64;
}
-common_config:
/*
* Firmware has an individual device recovery time typically
* of 35 seconds, give us a margin.
--
2.7.4
