From: James Smart <jsmart2021@xxxxxxxxx>
In the lpfc_nvme_io_cmd_wqe_cmpl routine the driver was printing two
pointers and the DID for the rport whenever an IO completed on a now
that had transitioned to a non active state.
There is no need to print the node pointer address for a node that
is not active the DID should be enough to debug.
Signed-off-by: Dick Kennedy <dick.kennedy@xxxxxxxxxxxx>
Signed-off-by: James Smart <james.smart@xxxxxxxxxxxx>
---
drivers/scsi/lpfc/lpfc_nvme.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/scsi/lpfc/lpfc_nvme.c b/drivers/scsi/lpfc/lpfc_nvme.c
index 2a87428..bc6946f 100644
--- a/drivers/scsi/lpfc/lpfc_nvme.c
+++ b/drivers/scsi/lpfc/lpfc_nvme.c
@@ -787,9 +787,8 @@ lpfc_nvme_io_cmd_wqe_cmpl(struct lpfc_hba *phba, struct lpfc_iocbq *pwqeIn,
ndlp = rport->ndlp;
if (!ndlp || !NLP_CHK_NODE_ACT(ndlp)) {
lpfc_printf_vlog(vport, KERN_ERR, LOG_NODE | LOG_NVME_IOERR,
- "6061 rport %p, ndlp %p, DID x%06x ndlp "
- "not ready.\n",
- rport, ndlp, rport->remoteport->port_id);
+ "6061 rport %p, DID x%06x node not ready.\n",
+ rport, rport->remoteport->port_id);
ndlp = lpfc_findnode_did(vport, rport->remoteport->port_id);
if (!ndlp) {
--
2.1.0
