Commit "mpt3sas: Force request partial completion alignment" was not
considering the case of REQ_TYPE_FS commands not operating on sector
size units (e.g. REQ_OP_ZONE_REPORT and its 64B aligned partial
replies). This could result is incorrectly retrying (forever) those
commands.
Move the partial completion alignement check of mpt3sas to a generic
implementation in sd_done so that the check comes after good_bytes and
resid corrections done in that function depending on the request
command. The check is added to the initial command switch so that
commands with special payload size handling are ignored.
Signed-off-by: Damien Le Moal <damien.lemoal@xxxxxxx>
---
Changes from v3:
- Moved check to initial switch-case so that commands with special payload
handling are ignored.
Changes from v2:
- Fixed good_bytes calculation after correction of unaligned resid
It should be good_bytes=scsi_buflen() - resid, and not good_bytes-=resid
drivers/scsi/mpt3sas/mpt3sas_scsih.c | 15 ---------------
drivers/scsi/sd.c | 20 ++++++++++++++++++++
2 files changed, 20 insertions(+), 15 deletions(-)
diff --git a/drivers/scsi/mpt3sas/mpt3sas_scsih.c b/drivers/scsi/mpt3sas/mpt3sas_scsih.c
index 0b5b423..1961535 100644
--- a/drivers/scsi/mpt3sas/mpt3sas_scsih.c
+++ b/drivers/scsi/mpt3sas/mpt3sas_scsih.c
@@ -4658,7 +4658,6 @@ _scsih_io_done(struct MPT3SAS_ADAPTER *ioc, u16 smid, u8 msix_index, u32 reply)
struct MPT3SAS_DEVICE *sas_device_priv_data;
u32 response_code = 0;
unsigned long flags;
- unsigned int sector_sz;
mpi_reply = mpt3sas_base_get_reply_virt_addr(ioc, reply);
scmd = _scsih_scsi_lookup_get_clear(ioc, smid);
@@ -4717,20 +4716,6 @@ _scsih_io_done(struct MPT3SAS_ADAPTER *ioc, u16 smid, u8 msix_index, u32 reply)
}
xfer_cnt = le32_to_cpu(mpi_reply->TransferCount);
-
- /* In case of bogus fw or device, we could end up having
- * unaligned partial completion. We can force alignment here,
- * then scsi-ml does not need to handle this misbehavior.
- */
- sector_sz = scmd->device->sector_size;
- if (unlikely(scmd->request->cmd_type == REQ_TYPE_FS && sector_sz &&
- xfer_cnt % sector_sz)) {
- sdev_printk(KERN_INFO, scmd->device,
- "unaligned partial completion avoided (xfer_cnt=%u, sector_sz=%u)\n",
- xfer_cnt, sector_sz);
- xfer_cnt = round_down(xfer_cnt, sector_sz);
- }
-
scsi_set_resid(scmd, scsi_bufflen(scmd) - xfer_cnt);
if (ioc_status & MPI2_IOCSTATUS_FLAG_LOG_INFO_AVAILABLE)
log_info = le32_to_cpu(mpi_reply->IOCLogInfo);
diff --git a/drivers/scsi/sd.c b/drivers/scsi/sd.c
index 1f5d92a..d05a328 100644
--- a/drivers/scsi/sd.c
+++ b/drivers/scsi/sd.c
@@ -1790,6 +1790,8 @@ static int sd_done(struct scsi_cmnd *SCpnt)
{
int result = SCpnt->result;
unsigned int good_bytes = result ? 0 : scsi_bufflen(SCpnt);
+ unsigned int sector_size = SCpnt->device->sector_size;
+ unsigned int resid;
struct scsi_sense_hdr sshdr;
struct scsi_disk *sdkp = scsi_disk(SCpnt->request->rq_disk);
struct request *req = SCpnt->request;
@@ -1820,6 +1822,24 @@ static int sd_done(struct scsi_cmnd *SCpnt)
scsi_set_resid(SCpnt, blk_rq_bytes(req));
}
break;
+ default:
+ /*
+ * In case of bogus fw or device, we could end up having
+ * an unaligned partial completion. Check this here and force
+ * alignment.
+ */
+ resid = scsi_get_resid(SCpnt);
+ if (resid & (sector_size - 1)) {
+ SCSI_LOG_HLCOMPLETE(1, scmd_printk(KERN_INFO, SCpnt,
+ "Unaligned partial completion (resid=%u, sector_sz=%u)\n",
+ resid, sector_size));
+ resid = round_up(resid, sector_size);
+ if (resid < good_bytes)
+ good_bytes -= resid;
+ else
+ good_bytes = 0;
+ scsi_set_resid(SCpnt, resid);
+ }
}
if (result) {
--
2.9.3
