https://bugzilla.kernel.org/show_bug.cgi?id=179341 --- Comment #8 from Chaitra P B <chaitra.basappa@xxxxxxxxxxxx> --- (In reply to Badalyan Vyacheslav from comment #7) > Help is needed. How to get a log FW? > > This is "SAS 9300-16i Host Bus Adapter" and not have any HW RAID. > > [root@nas sas3ircu_linux_x64_rel]# ./sas3ircu 0 LOGIR > Avago Technologies SAS3 IR Configuration Utility. > Version 14.00.00.00 (2016.07.21) > Copyright (c) 2009-2016 Avago Technologies. All rights reserved. > > SAS3IRCU: The LOGIR command is not supported by the firmware currently > loaded on controller 0. > > [root@nas sas3ircu_linux_x64_rel]# ./sas3ircu list > Avago Technologies SAS3 IR Configuration Utility. > Version 14.00.00.00 (2016.07.21) > Copyright (c) 2009-2016 Avago Technologies. All rights reserved. > > > Adapter Vendor Device SubSys SubSys > Index Type ID ID Pci Address Ven ID Dev ID > ----- ------------ ------ ------ ----------------- ------ ------ > 0 SAS3008 1000h 97h 00h:0ah:00h:00h 1000h 3130h > > Adapter Vendor Device SubSys SubSys > Index Type ID ID Pci Address Ven ID Dev ID > ----- ------------ ------ ------ ----------------- ------ ------ > 1 SAS3008 1000h 97h 00h:08h:00h:00h 1000h 3130h > SAS3IRCU: Utility Completed Successfully. Badalyan, Connect UART to controller, then open Teraterm window & use below commands: "iop show diag" -> outputs ring buffer and trace buffer. "pl dbg" -> outputs other debug info. -- You are receiving this mail because: You are watching someone on the CC list of the bug. -- To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
