Hello,
I have a question regarding the support condition of the aic79xx driver.
I am running kernel version 2.6.14 (gentoo) on a dual processor system
PCI-X system. I am using an Adaptec scsi adapter to run an HP Ultrium
tape drive. Nothing else is attached to the controller.
I was previously using an Adaptec 29160N (aic7892), which is a 32 bit,
66Mhz controller. With this controller, the tape was not able to
maintain full streaming, or achieve full speed. Average rate was
approximately 27MB per second. In order to address the performance
problem, HP recommended that I change to a 64 bit U160 or U320 controller.
I've put in an Adaptec 29320ALP-R (aic7901), which is a 32 bit, 133Mhz
controller. With this controller, performance has dropped to an abysmal
2.7MB per second!
I am running the controller at 133Mhz, but I have also tried locking it
to 66Mhz with no effect. I am using the same cable with both
controllers, and the terminator is built into the cable. Nothing stands
out in /var/log/messages.
So, can anyone offer ideas as to why the 79xx controller performs at one
tenth the rate of the 78xx controller and how to fix it? Any help
appreciated.
Thanks,
Denny
-
: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
