-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hi! Ingo Flaschberger schrieb: > Hello, > > I have troubles with a not full supported > Adaptec AIC-7902 U320 w/HostRAID (rev 03) (no hostraid support). > > I'm doing now software raid and have spurious scsi bus resets when high > load is at the discs. Currently the machines runs at only 1 disk, but > the problems happens with 2 or with 1 disk. > The disk's are quite old, 3 years. > Last week I had a hard time with the aic79xx driver too (see the thread on this list with subject "SCSI error: Infinite interrupt loop, INTSTAT = 0" starting at 22th of this month) But this was a problem with Adaptec 29320A cards (aic7901 chip) and an externally connected RAID subsystem where my internally connected U320 drives on a aic7902B controller chip (Tyan Transport TA26 built-in) do work fine. I looks like your case is different... > My question is, are the disks producing the problems or the controller > itself? > What could I do / change? > > System: dual intel xeon > kernel version: 2.4.20-021stab028.18.777-smp > You could try to upgrade to a newer aic79xx driver (you can find the newest aic79xx driver at <http://people.freebsd.org/~gibbs/linux/> Current version is 2.0.12. But be aware that this version did not help with the problems I had last week. You could also try to use a different scsi controller brand. I always had good success with LSI logic controllers (as was the case with the problems I had last week: replace the Adaptec controller with the LSI logic controller and suddenly everything works fine). And of course you can do the usual hardware replacements (cable, disks, terminator, ...) to check if the problem changes in any way. HTH - - andreas - -- Andreas Haumer | mailto:andreas@xxxxxxxxx *x Software + Systeme | http://www.xss.co.at/ Karmarschgasse 51/2/20 | Tel: +43-1-6060114-0 A-1100 Vienna, Austria | Fax: +43-1-6060114-71 -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.2 (GNU/Linux) Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org iD8DBQFDiuLvxJmyeGcXPhERAorNAJ0fsJtkandHnE+zjGZmJ15/I+XQrQCfWjT1 104yC6RvYHLEJF6dijbzAGM= =sx6e -----END PGP SIGNATURE----- - : send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
