Brown, Len wrote:
[ 279.662960] [<c02d5c74>] wait_for_completion+0xa4/0x110
possibly a missing interrupt?
CONFIG_ACPI=y
any difference if booted with "acpi=off" or "acpi=noirq"?
Yes. In both cases, the system appears to boot normally but I'm unable
to login or connect via ssh. Also there's a "device not ready" message
after the scsi initialization which I don't normally see. I've attached
the scsi initialization output. The PF_NETLINK error messages after the
login prompt in this output are created whenever I try to log in or
connect via ssh.
Peter
--
Peter Williams pwil3058@xxxxxxxxxxxxxx
"Learning, n. The kind of ignorance distinguishing the studious."
-- Ambrose Bierce
[ 8.345086] SCSI subsystem initialized
[ 8.427503] sym0: <810a> rev 0x23 at pci 0000:00:08.0 irq 16
[ 8.504636] sym0: No NVRAM, ID 7, Fast-10, SE, parity checking
[ 8.588216] sym0: SCSI BUS has been reset.
[ 8.642194] scsi0 : sym-2.2.1
[ 12.368622] Vendor: PIONEER Model: DVD-ROM DVD-303R Rev: 2.00
[ 12.450118] Type: CD-ROM ANSI SCSI revision:2[ 12.546506] target0:0:2: Beginning Domain Validation
[ 12.613354] target0:0:2: asynchronous.
[ 12.667699] target0:0:2: Domain Validation skipping write tests
[ 12.747629] target0:0:2: FAST-10 SCSI 10.0 MB/s ST (100 ns, offset 8)
[ 12.837395] target0:0:2: Ending Domain Validation
[ 13.256875] Vendor: SONY Model: CD-RW CRX140S Rev: 1.0e
[ 13.338323] Type: CD-ROM ANSI SCSI revision:4[ 13.434891] target0:0:4: Beginning Domain Validation
[ 13.503101] target0:0:4: asynchronous.
[ 13.602931] target0:0:4: Domain Validation skipping write tests
[ 13.683605] target0:0:4: FAST-10 SCSI 10.0 MB/s ST (100 ns, offset 8)
[ 13.777934] target0:0:4: Ending Domain Validation
[ 14.884703] Device not ready.
[ 15.763312] kjournald starting. Commit interval 5 seconds
[ 15.835612] EXT3-fs: mounted filesystem with ordered data mode.
Fedora Core release 4 (Stentz)
Kernel 2.6.13-mm1 on an i686
origma.pw.nest login:
[ 101.886572] DEBUG: Failed to load PF_NETLINK protocol 9
[ 101.963572] DEBUG: Failed to load PF_NETLINK protocol 9
