Hi, I do not know which list to put this problem on. And hence ... I'm using Kernel 2.6.9 and am having a Qlogic QLE2362 FC-HBA in my system. I selected all the Qlogic SCSI drivers while buiding the kernel. Now the problem is that every time I reboot, I have to MANUALLY modprobe the qla2322.ko module in the kernel and only then my HBA works. By default, the kernel loads qla2300.ko, which is not the correct driver for the card, and hence the HBA does not work. Here is the lspci output: ----------------------------------------------------------------- 0d:07.1 Fibre Channel: QLogic Corp.: Unknown device 2322 (rev 03) Subsystem: QLogic Corp.: Unknown device 0118 Flags: bus master, 66Mhz, medium devsel, latency 128, IRQ 185 I/O ports at 6400 [size=256] Memory at d0401000 (64-bit, non-prefetchable) [size=4K] Capabilities: [44] Power Management version 2 Capabilities: [4c] PCI-X non-bridge device. Capabilities: [54] Message Signalled Interrupts: 64bit+ Queue=0/3 Enable- ------------------------------------------------------------------- Here is the relevant extract from modules.pcimap: ------------------------------------------------------------------- #module vendor device subvendor subdevice class class_mask driver_data qla2300 0x00001077 0x00002300 0xffffffff 0xffffffff 0x00000000 0x00000000 0x0 qla2300 0x00001077 0x00002312 0xffffffff 0xffffffff 0x00000000 0x00000000 0x0 qla2322 0x00001077 0x00002322 0xffffffff 0xffffffff 0x00000000 0x00000000 0x0 ------------------------------------------------------------------- As can be seen from above, qla2322 is the correct driver for device 2322 (My QLE2362 HBA has a device no 2322, as seen in lspci output). But for some reason the kernel always loads qla2300 instead on qla2322. I even tried putting the "qla2322" line on top of the two "qla2300" lines in the modules.pcimap file. But with no result. TIA, Rajat - : send the line "unsubscribe linux-scsi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
