On 26.01.2018 13:09, Andrzej Hajda wrote:
> HSI2C_MASTER_ST_LOSE state is not documented properly, extensive tests
> show that hardware is usually able to recover from this state without
> interrupting the transfer. Moreover documentation says that
> such state can be caused by slave clock stretching, and should not be
> treated as an error during transaction. The only place it indicates
> an error is just before starting transaction. In such case bus recovery
> procedure should be performed - master should pulse SCL line nine times
> and then send STOP condition, it can be repeated until SDA goes high.
> The procedure can be performed using manual commands HSI2C_CMD_READ_DATA
> and HSI2C_CMD_SEND_STOP.
>
> Signed-off-by: Andrzej Hajda <a.hajda@xxxxxxxxxxx>
> ---
> Hi Wolfram,
>
> This patch integrates and invalidates my previous patches [1][2].
> I hope inline comments are sufficient.
Gentle ping.
--
Regards
Andrzej
>
> [1]: i2c: exynos5: implement bus recovery functionality
> [2]: i2c: exynos5: do not check TRANS_STATUS in case of Exynos7 variant
>
> Regards
> Andrzej
>
> drivers/i2c/busses/i2c-exynos5.c | 67 ++++++++++++++++++++++++++++++++++++----
> 1 file changed, 61 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/i2c/busses/i2c-exynos5.c b/drivers/i2c/busses/i2c-exynos5.c
> index b02428498f6d..8dcc36835a1a 100644
> --- a/drivers/i2c/busses/i2c-exynos5.c
> +++ b/drivers/i2c/busses/i2c-exynos5.c
> @@ -128,6 +128,10 @@
> #define HSI2C_TIMEOUT_EN (1u << 31)
> #define HSI2C_TIMEOUT_MASK 0xff
>
> +/* I2C_MANUAL_CMD register bits */
> +#define HSI2C_CMD_READ_DATA (1u << 4)
> +#define HSI2C_CMD_SEND_STOP (1u << 2)
> +
> /* I2C_TRANS_STATUS register bits */
> #define HSI2C_MASTER_BUSY (1u << 17)
> #define HSI2C_SLAVE_BUSY (1u << 16)
> @@ -441,12 +445,6 @@ static irqreturn_t exynos5_i2c_irq(int irqno, void *dev_id)
> i2c->state = -ETIMEDOUT;
> goto stop;
> }
> -
> - trans_status = readl(i2c->regs + HSI2C_TRANS_STATUS);
> - if ((trans_status & HSI2C_MASTER_ST_MASK) == HSI2C_MASTER_ST_LOSE) {
> - i2c->state = -EAGAIN;
> - goto stop;
> - }
> } else if (int_status & HSI2C_INT_I2C) {
> trans_status = readl(i2c->regs + HSI2C_TRANS_STATUS);
> if (trans_status & HSI2C_NO_DEV_ACK) {
> @@ -544,6 +542,61 @@ static int exynos5_i2c_wait_bus_idle(struct exynos5_i2c *i2c)
> return -EBUSY;
> }
>
> +static void exynos5_i2c_bus_recover(struct exynos5_i2c *i2c)
> +{
> + u32 val;
> +
> + dev_dbg(i2c->dev, "%s: start\n", __func__);
> +
> + val = readl(i2c->regs + HSI2C_CTL) | HSI2C_RXCHON;
> + writel(val, i2c->regs + HSI2C_CTL);
> + val = readl(i2c->regs + HSI2C_CONF) & ~HSI2C_AUTO_MODE;
> + writel(val, i2c->regs + HSI2C_CONF);
> +
> + /*
> + * Specification says master should send nine clock pulses. It can be
> + * emulated by sending manual read command (nine pulses for read eight
> + * bits + one pulse for NACK).
> + */
> + writel(HSI2C_CMD_READ_DATA, i2c->regs + HSI2C_MANUAL_CMD);
> + exynos5_i2c_wait_bus_idle(i2c);
> + writel(HSI2C_CMD_SEND_STOP, i2c->regs + HSI2C_MANUAL_CMD);
> + exynos5_i2c_wait_bus_idle(i2c);
> +
> + val = readl(i2c->regs + HSI2C_CTL) & ~HSI2C_RXCHON;
> + writel(val, i2c->regs + HSI2C_CTL);
> + val = readl(i2c->regs + HSI2C_CONF) | HSI2C_AUTO_MODE;
> + writel(val, i2c->regs + HSI2C_CONF);
> +
> + dev_dbg(i2c->dev, "%s: end\n", __func__);
> +}
> +
> +static void exynos5_i2c_bus_check(struct exynos5_i2c *i2c)
> +{
> + unsigned long timeout;
> +
> + if (i2c->variant->hw != HSI2C_EXYNOS7)
> + return;
> +
> + /*
> + * HSI2C_MASTER_ST_LOSE state in EXYNOS7 variant before transaction
> + * indicates that bus is stuck (SDA is low). In such case bus recovery
> + * can be performed.
> + */
> + timeout = jiffies + msecs_to_jiffies(100);
> + for (;;) {
> + u32 st = readl(i2c->regs + HSI2C_TRANS_STATUS);
> +
> + if ((st & HSI2C_MASTER_ST_MASK) != HSI2C_MASTER_ST_LOSE)
> + return;
> +
> + if (time_is_before_jiffies(timeout))
> + return;
> +
> + exynos5_i2c_bus_recover(i2c);
> + }
> +}
> +
> /*
> * exynos5_i2c_message_start: Configures the bus and starts the xfer
> * i2c: struct exynos5_i2c pointer for the current bus
> @@ -598,6 +651,8 @@ static void exynos5_i2c_message_start(struct exynos5_i2c *i2c, int stop)
> writel(fifo_ctl, i2c->regs + HSI2C_FIFO_CTL);
> writel(i2c_ctl, i2c->regs + HSI2C_CTL);
>
> + exynos5_i2c_bus_check(i2c);
> +
> /*
> * Enable interrupts before starting the transfer so that we don't
> * miss any INT_I2C interrupts.
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
