In case of arbitration lost adequate interrupt sometimes is not signaled. As
a result transfer timeouts and is not retried, as it should. To avoid such
cases code is added to check transaction status in case of every interrupt.
Signed-off-by: Andrzej Hajda <a.hajda@xxxxxxxxxxx>
---
Hi,
I am not I2C specialist, this patch is a result of debugging issues
with SiI8620 MHL driver on TM2 device. I guess the main problem is
with SiI8620 chip, but exynos5 i2c is also guilty - with i2c-gpio driver
it works correctly - there is only one arbitration lost at 1st transaction
(which is properly handled - transfer is repeated succesfully). In case
of exynos5 there are much more arbitration losts. Lowering bus speed
decreases frequency of losts but do not eliminate them.
Any help/hint, what could cause such issues?
I guess increasing adap.retries should also decrease fail probability,
currently for exynos5 it is set to 3.
Regards
Andrzej
---
drivers/i2c/busses/i2c-exynos5.c | 28 +++++++++++++++++++++++++++-
1 file changed, 27 insertions(+), 1 deletion(-)
diff --git a/drivers/i2c/busses/i2c-exynos5.c b/drivers/i2c/busses/i2c-exynos5.c
index bea6071..a01c1ae 100644
--- a/drivers/i2c/busses/i2c-exynos5.c
+++ b/drivers/i2c/busses/i2c-exynos5.c
@@ -130,12 +130,32 @@
/* I2C_TRANS_STATUS register bits */
#define HSI2C_MASTER_BUSY (1u << 17)
#define HSI2C_SLAVE_BUSY (1u << 16)
+
+/* I2C_TRANS_STATUS register bits for Exynos5 variant */
#define HSI2C_TIMEOUT_AUTO (1u << 4)
#define HSI2C_NO_DEV (1u << 3)
#define HSI2C_NO_DEV_ACK (1u << 2)
#define HSI2C_TRANS_ABORT (1u << 1)
#define HSI2C_TRANS_DONE (1u << 0)
+/* I2C_TRANS_STATUS register bits for Exynos7 variant */
+#define HSI2C_MASTER_ST_MASK 0xf
+#define HSI2C_MASTER_ST_IDLE 0x0
+#define HSI2C_MASTER_ST_START 0x1
+#define HSI2C_MASTER_ST_RESTART 0x2
+#define HSI2C_MASTER_ST_STOP 0x3
+#define HSI2C_MASTER_ST_MASTER_ID 0x4
+#define HSI2C_MASTER_ST_ADDR0 0x5
+#define HSI2C_MASTER_ST_ADDR1 0x6
+#define HSI2C_MASTER_ST_ADDR2 0x7
+#define HSI2C_MASTER_ST_ADDR_SR 0x8
+#define HSI2C_MASTER_ST_READ 0x9
+#define HSI2C_MASTER_ST_WRITE 0xa
+#define HSI2C_MASTER_ST_NO_ACK 0xb
+#define HSI2C_MASTER_ST_LOSE 0xc
+#define HSI2C_MASTER_ST_WAIT 0xd
+#define HSI2C_MASTER_ST_WAIT_CMD 0xe
+
/* I2C_ADDR register bits */
#define HSI2C_SLV_ADDR_SLV(x) ((x & 0x3ff) << 0)
#define HSI2C_SLV_ADDR_MAS(x) ((x & 0x3ff) << 10)
@@ -437,6 +457,7 @@ static irqreturn_t exynos5_i2c_irq(int irqno, void *dev_id)
int_status = readl(i2c->regs + HSI2C_INT_STATUS);
writel(int_status, i2c->regs + HSI2C_INT_STATUS);
+ trans_status = readl(i2c->regs + HSI2C_TRANS_STATUS);
/* handle interrupt related to the transfer status */
if (i2c->variant->hw == HSI2C_EXYNOS7) {
@@ -460,8 +481,13 @@ static irqreturn_t exynos5_i2c_irq(int irqno, void *dev_id)
i2c->state = -ETIMEDOUT;
goto stop;
}
+
+ switch (trans_status & HSI2C_MASTER_ST_MASK) {
+ case HSI2C_MASTER_ST_LOSE:
+ i2c->state = -EAGAIN;
+ goto stop;
+ }
} else if (int_status & HSI2C_INT_I2C) {
- trans_status = readl(i2c->regs + HSI2C_TRANS_STATUS);
if (trans_status & HSI2C_NO_DEV_ACK) {
dev_dbg(i2c->dev, "No ACK from device\n");
i2c->state = -ENXIO;
--
2.7.4
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
