[PATCH 2/4 RESEND] spi: s3c64xx: extend driver to make full use of runtime PM autosuspend

[Heiner Kallweit <hkallweit1@xxxxxxxxx>]

Extend the driver to make full use of runtime PM autosuspend.
Before only the SPI core was instructed to use autosuspend
by setting master->auto_runtime_pm. Nevertheless due to the missing
pm_runtime_use_autosuspend call autosuspend wasn't active.

Signed-off-by: Heiner Kallweit <hkallweit1@xxxxxxxxx>
---
Changed:
- Let driver autosuspend also after leaving s3c64xx_spi_setup
- Enable runtime PM earlier in s3c64xx_spi_probe and prevent
  suspending in the relevant part of probe

 drivers/spi/spi-s3c64xx.c | 32 +++++++++++++++++++++-----------
 1 file changed, 21 insertions(+), 11 deletions(-)

diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
index 8a6ab88..edeac06 100644
--- a/drivers/spi/spi-s3c64xx.c
+++ b/drivers/spi/spi-s3c64xx.c
@@ -32,6 +32,7 @@
 #define MAX_SPI_PORTS		6
 #define S3C64XX_SPI_QUIRK_POLL		(1 << 0)
 #define S3C64XX_SPI_QUIRK_CS_AUTO	(1 << 1)
+#define AUTOSUSPEND_TIMEOUT	2000
 
 /* Registers and bit-fields */
 
@@ -859,13 +860,15 @@ static int s3c64xx_spi_setup(struct spi_device *spi)
 		}
 	}
 
-	pm_runtime_put(&sdd->pdev->dev);
+	pm_runtime_mark_last_busy(&sdd->pdev->dev);
+	pm_runtime_put_autosuspend(&sdd->pdev->dev);
 	if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
 		writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
 	return 0;
 
 setup_exit:
-	pm_runtime_put(&sdd->pdev->dev);
+	pm_runtime_mark_last_busy(&sdd->pdev->dev);
+	pm_runtime_put_autosuspend(&sdd->pdev->dev);
 	/* setup() returns with device de-selected */
 	if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
 		writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
@@ -1133,18 +1136,24 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
 		goto err0;
 	}
 
+	pm_runtime_set_autosuspend_delay(&pdev->dev, AUTOSUSPEND_TIMEOUT);
+	pm_runtime_use_autosuspend(&pdev->dev);
+	pm_runtime_set_active(&pdev->dev);
+	pm_runtime_enable(&pdev->dev);
+	pm_runtime_get_noresume(&pdev->dev);
+
 	/* Setup clocks */
 	sdd->clk = devm_clk_get(&pdev->dev, "spi");
 	if (IS_ERR(sdd->clk)) {
 		dev_err(&pdev->dev, "Unable to acquire clock 'spi'\n");
 		ret = PTR_ERR(sdd->clk);
-		goto err0;
+		goto err1;
 	}
 
 	if (clk_prepare_enable(sdd->clk)) {
 		dev_err(&pdev->dev, "Couldn't enable clock 'spi'\n");
 		ret = -EBUSY;
-		goto err0;
+		goto err1;
 	}
 
 	sprintf(clk_name, "spi_busclk%d", sci->src_clk_nr);
@@ -1180,13 +1189,10 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
 	       S3C64XX_SPI_INT_TX_OVERRUN_EN | S3C64XX_SPI_INT_TX_UNDERRUN_EN,
 	       sdd->regs + S3C64XX_SPI_INT_EN);
 
-	pm_runtime_set_active(&pdev->dev);
-	pm_runtime_enable(&pdev->dev);
-
 	ret = devm_spi_register_master(&pdev->dev, master);
 	if (ret != 0) {
 		dev_err(&pdev->dev, "cannot register SPI master: %d\n", ret);
-		goto err4;
+		goto err3;
 	}
 
 	dev_dbg(&pdev->dev, "Samsung SoC SPI Driver loaded for Bus SPI-%d with %d Slaves attached\n",
@@ -1195,15 +1201,19 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
 					mem_res, (FIFO_LVL_MASK(sdd) >> 1) + 1,
 					sdd->rx_dma.dmach, sdd->tx_dma.dmach);
 
+	pm_runtime_mark_last_busy(&pdev->dev);
+	pm_runtime_put_autosuspend(&pdev->dev);
+
 	return 0;
 
-err4:
-	pm_runtime_disable(&pdev->dev);
-	pm_runtime_set_suspended(&pdev->dev);
 err3:
 	clk_disable_unprepare(sdd->src_clk);
 err2:
 	clk_disable_unprepare(sdd->clk);
+err1:
+	pm_runtime_put_noidle(&pdev->dev);
+	pm_runtime_disable(&pdev->dev);
+	pm_runtime_set_suspended(&pdev->dev);
 err0:
 	spi_master_put(master);
 
-- 
2.5.0


--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html