W dniu 13.02.2015 o 19:03, Javier Martinez Canillas pisze:
> Hello Andrzej,
>
> On Fri, Feb 13, 2015 at 8:48 AM, Andrzej Hajda <a.hajda@xxxxxxxxxxx> wrote:
>> The patch adds gpio for detecting presence of MMC card.
>> It fixes issue with kernel hang due when MMC card is missing.
>
> Maybe s/MMC/eMMC here? to make more clear that this patch is solving
> an issue when the eMMC and not the uSD is missing.
>
>>
>> Signed-off-by: Andrzej Hajda <a.hajda@xxxxxxxxxxx>
>> ---
>> Hi,
>>
>> This is just resend of the patch with added mmc ML and dw-mmc maintainers.
>>
>> Javier, I have no access to peach-pi(t) schematics, so I do not know if they
>> have mmc-cd line connected to gpc0-2 gpio, but I guess it could be the case.
>> You could check if similar patches will fix the issue for them.
>>
>
> Yes, both the eMMC and uSD card detection lines in the Peach Pit/Pi
> are connected to the XMMC0CDN and XMMC2CDN built-in CD# pins so is the
> same than the Odroid XU3 if I read the schematics correctly since the
> those pins are also GPC0_2 and GPC2_2.
>
> Now, in the Peach Pit Chromebook the eMMC is not removable so card
> detection is not an issue there, the problem I'm having is that card
> detection for the uSD seems to be broken after adding Addy's patches:
>
> mmc: dw_mmc: fix bug that cause 'Timeout sending command'
> mmc: dw_mmc: Don't start command while data busy
>
> And adding a cd-gpios property with a phandle to gpc2_2 to the mmc2
> device node does not help.
>
> But without those patches, I've timeouts when mmc commands are sent to
> the SDIO slot which has the wifi chip connected to.
>
>> Regards
>> Andrzej
>>
>> arch/arm/boot/dts/exynos5422-odroidxu3.dts | 5 +++--
>> 1 file changed, 3 insertions(+), 2 deletions(-)
>>
>> diff --git a/arch/arm/boot/dts/exynos5422-odroidxu3.dts b/arch/arm/boot/dts/exynos5422-odroidxu3.dts
>> index 47ec9bf..a563811 100644
>> --- a/arch/arm/boot/dts/exynos5422-odroidxu3.dts
>> +++ b/arch/arm/boot/dts/exynos5422-odroidxu3.dts
>> @@ -11,6 +11,7 @@
>> */
>>
>> /dts-v1/;
>> +#include <dt-bindings/gpio/gpio.h>
>> #include "exynos5800.dtsi"
>>
>> / {
>> @@ -355,13 +356,13 @@
>>
>> &mmc_0 {
>> status = "okay";
>> - broken-cd;
>> + cd-gpios = <&gpc0 2 GPIO_ACTIVE_LOW>;
>> card-detect-delay = <200>;
>> samsung,dw-mshc-ciu-div = <3>;
>> samsung,dw-mshc-sdr-timing = <0 4>;
>> samsung,dw-mshc-ddr-timing = <0 2>;
>> pinctrl-names = "default";
>> - pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_bus4 &sd0_bus8>;
>> + pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_bus4 &sd0_bus8 &sd0_cd>;
>> bus-width = <8>;
>> cap-mmc-highspeed;
>> };
>> --
>
> Your patch looks good to me though from what I've seen in the Odroid
> XU3 schematic and taking into account that the eMMC can be removed in
> that board.
>
> Reviewed-by: Javier Martinez Canillas <javier.martinez@xxxxxxxxxxxxxxx>
Hi Andrzej,
The patch no longer applies cleanly, so could you re-spin it with
Javier's tag above?
Best regards,
Krzysztof
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
