On Thu, Dec 18, 2014 at 9:34 AM, Vasily Khoruzhick <anarsoul@xxxxxxxxx> wrote: > Can I change pin function after gpio was requested? In low-power state > (i.e. when display is disabled) it's gpio driving some level, > and in active state it's some LCD controller pin (don't remember which > one exactly) Please read the section named "GPIO mode pitfalls" in Documentation/pinctrl.txt very closely. Two ways: - You can use the GPIO and pin control interface to the same hardware in parallel. There is no blocking this since there is hardware out that that actually allow this. NOT RECOMMENDED. - If the "GPIO mode" mentioned is only about e.g. grounding the pins in a low power state and then not really about using them as GPIO, extend the pin controller to be able to e.g. ground the pins with PIN_CONFIG_OUTPUT or PIN_CONFIG_LOW_POWER_MODE if you use generic bindings. If the usecase is low power, the latter approach is recommended. Yours, Linus Walleij -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |