Some regulators can run on different operating modes (opmodes). This allows systems to choose the most efficient opmode for each regulator. This patch builds on top of (291d761 regulator: Document binding for regulator suspend state for PM state) adding a regulator-initial-mode DT property to configure at startup the operating mode for regulators that support changing its mode during normal operation and a property regulator-mode to be used in the regulator-state-[mem/disk] nodes for regulators that supports changing its operating mode when the system enters in a suspend state. The set of possible modes that a regulator can operate depends on the hardware capabilities so a list of generic operating modes can't be provided. Instead, each hardware binding should define the list of valid operating modes for the regulators found on that device. Signed-off-by: Javier Martinez Canillas <javier.martinez@xxxxxxxxxxxxxxx> --- Changes in v5: None Changes in v4: None Changes in v3: - Rebased on top of regulator suspend voltage series Documentation/devicetree/bindings/regulator/regulator.txt | 14 ++++++++++++++ 1 file changed, 14 insertions(+) diff --git a/Documentation/devicetree/bindings/regulator/regulator.txt b/Documentation/devicetree/bindings/regulator/regulator.txt index 4e7ed76..3fffa3b 100644 --- a/Documentation/devicetree/bindings/regulator/regulator.txt +++ b/Documentation/devicetree/bindings/regulator/regulator.txt @@ -30,6 +30,20 @@ Optional properties: - regulator-off-in-suspend: regulator should be off in suspend state. - regulator-suspend-microvolt: regulator should be set to this voltage in suspend. + - regulator-mode: operating mode in the given suspend state. + The set of possible operating modes depends on the capabilities of + every hardware so the valid modes are documented on each regulator + device tree binding document. + The "regulator-mode" property only takes effect if the regulator is + enabled for the given suspend state using "regulator-on-in-suspend". + If the regulator has not been explicitly disabled for the given state + with "regulator-off-in-suspend", then setting the operating mode + will also have no effect. +- regulator-initial-mode: initial operating mode. The set of possible operating + modes is the same used for the regulator-mode property and the device binding + documentation explains which property each regulator supports. +If no mode is defined, then the OS will not manage the modes and the hardware +default values will be used instead. Deprecated properties: - regulator-compatible: If a regulator chip contains multiple -- 2.1.0 -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |