Hello Mark, On 08/22/2014 04:45 PM, Mark Brown wrote: > On Fri, Aug 22, 2014 at 02:15:46PM +0200, Javier Martinez Canillas wrote: > >> Mark, any opinions on how this should be solved will be highly appreciated. > > If someone could tell me what "this" is that'd help... > Sorry for not being clear on that regard. By "this" I meant the problem reported by Yuvaraj. The regulators operating mode is read from the hardware registers on probe as you suggested but that means that if the regulator is disabled and the machine rebooted (warm reset) the opmode reported by the hardware is MAX77802_OPMODE_OFF. The problem is that one of these regulators is used as the vqmmc-supply (VCCQ/VDD_IO) so the mmc host controller driver disables it on MMC_POWER_OFF. Now AFAIK (Yuvaraj can correct me what I got wrong) this shouldn't be an issue since on card detection, the vqmmc supply should be enabled again but on Exynos the built-in card detect line is on the same power rail as vqmmc. That means that disabling the regulator prevents card insertions to be detected. This does not happen on the downstream Chrome OS kernel because the max77802 regulator driver has some ad-hoc DT bindings were you can define the operating mode to be set on probe. For this particular regulator is MAX77802_OPMODE_STANDBY. Yuvaraj solution was to set the operating mode to MAX77802_OPMODE_NORMAL on probe() which was what I did on a previous version of the driver but you explained to me that it was not safe to do that. That's why I'm asking for suggestions. Thanks a lot and best regards, Javier -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |