In a multiplatform config, the low level debug option shows several UART port entries. Improve the user visible string so that it becomes clear to the user about Samsung UART ports. While at it also remove some lines from the help text that are no longer applicable across all Samsung platforms. Signed-off-by: Sachin Kamat <sachin.kamat@xxxxxxxxxxx> --- arch/arm/Kconfig.debug | 20 ++++---------------- 1 file changed, 4 insertions(+), 16 deletions(-) diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug index 3548612b0bfe..b92993e59a12 100644 --- a/arch/arm/Kconfig.debug +++ b/arch/arm/Kconfig.debug @@ -617,53 +617,41 @@ choice depends on PLAT_SAMSUNG select DEBUG_EXYNOS_UART if ARCH_EXYNOS select DEBUG_S3C24XX_UART if ARCH_S3C24XX - bool "Use S3C UART 0 for low-level debug" + bool "Use Samsung S3C UART 0 for low-level debug" help Say Y here if you want the debug print routines to direct their output to UART 0. The port must have been initialised by the boot-loader before use. - The uncompressor code port configuration is now handled - by CONFIG_S3C_LOWLEVEL_UART_PORT. - config DEBUG_S3C_UART1 depends on PLAT_SAMSUNG select DEBUG_EXYNOS_UART if ARCH_EXYNOS select DEBUG_S3C24XX_UART if ARCH_S3C24XX - bool "Use S3C UART 1 for low-level debug" + bool "Use Samsung S3C UART 1 for low-level debug" help Say Y here if you want the debug print routines to direct their output to UART 1. The port must have been initialised by the boot-loader before use. - The uncompressor code port configuration is now handled - by CONFIG_S3C_LOWLEVEL_UART_PORT. - config DEBUG_S3C_UART2 depends on PLAT_SAMSUNG select DEBUG_EXYNOS_UART if ARCH_EXYNOS select DEBUG_S3C24XX_UART if ARCH_S3C24XX - bool "Use S3C UART 2 for low-level debug" + bool "Use Samsung S3C UART 2 for low-level debug" help Say Y here if you want the debug print routines to direct their output to UART 2. The port must have been initialised by the boot-loader before use. - The uncompressor code port configuration is now handled - by CONFIG_S3C_LOWLEVEL_UART_PORT. - config DEBUG_S3C_UART3 depends on PLAT_SAMSUNG && ARCH_EXYNOS select DEBUG_EXYNOS_UART - bool "Use S3C UART 3 for low-level debug" + bool "Use Samsung S3C UART 3 for low-level debug" help Say Y here if you want the debug print routines to direct their output to UART 3. The port must have been initialised by the boot-loader before use. - The uncompressor code port configuration is now handled - by CONFIG_S3C_LOWLEVEL_UART_PORT. - config DEBUG_S3C2410_UART0 depends on ARCH_S3C24XX select DEBUG_S3C2410_UART -- 1.7.9.5 -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |