On 11.06.2014 19:27, Javier Martinez Canillas wrote: > On 06/11/2014 01:38 PM, Naveen Krishna Ch wrote: >> On 11 June 2014 16:43, Javier Martinez Canillas >> <javier.martinez@xxxxxxxxxxxxxxx> wrote: >>> On 06/11/2014 08:31 AM, Naveen Krishna Chatradhi wrote: [snip] >>> >>>> return ERR_PTR(-EINVAL); >>>> } >>>> + cs->line = spi->cs_gpio; >>>> >>> >>> I wonder why are you keeping cs->line? AFAICT it's only used in >>> s3c64xx_spi_setup() to request the GPIO and since you get the struct spi_device >>> pointer as a parameter then you can just use spi->s_gpio instead. >> I'm trying not to touch the non-DT part of the code. >> >> struct s3c64xx_spi_csinfo *cs = spi->controller_data; >> >> This will update the cs->line and cs->fb_delay in case of non-DT. > > I see, then I prefer the opposite and do something like this on s3c64xx_spi_probe(): > > if (!pdev->dev.of_node) > spi->cs_gpio = cs->line; Hmm, as far as I understand, spi here is spi_device, not spi_master. I don't think you have access to SPI devices on your bus in controller probe(). What I think could work is reworking the driver to: - in DT case, don't do anything in the driver about the GPIO chip select, because it will be handled automatically by the core. - in non-DT case, in s3c64xx_spi_setup(), just take the GPIO pin from s3c64xx_spi_csinfo struct passed through spi->controller_data, request it and save it to spi->cs_gpio, - in non-DT case, in s3c64xx_spi_cleanup(), free the GPIO requested in s3c64xx_spi_setup() and set spi->cs_gpio to -ENOENT (as done initially in spi_alloc_device()). Best regards, Tomasz -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |