Hello Mark,
Thanks a lot for your feedback.
On 06/09/2014 09:38 PM, Mark Brown wrote:
> On Mon, Jun 09, 2014 at 11:37:47AM +0200, Javier Martinez Canillas wrote:
>
>> + case REGULATOR_MODE_STANDBY: /* switch off */
>> + if (id != MAX77802_LDO1 && id != MAX77802_LDO20 &&
>> + id != MAX77802_LDO21 && id != MAX77802_LDO3) {
>> + val = MAX77802_OPMODE_STANDBY;
>> + break;
>> + }
>> + /* no break */
>
> This sounds very broken...
>
The problem is that not all regulators supports the same operational modes. For
instance regulators LDO 1, 20, 21 and 3 does not support REGULATOR_MODE_STANDBY
so if the condition is not met a break is not needed since the default case is
to warn that the mode is not supported.
But I'll rework that logic on v2 to make it cleaner and have a break on each
case and don't rely on case cascading.
>> + /* OK if some GPIOs aren't defined */
>> + if (!gpio_is_valid(gpio))
>> + continue;
>> +
>> + /* If a GPIO is valid, we'd better be able to claim it */
>> + ret = devm_gpio_request_one(dev, gpio, GPIOF_OUT_INIT_HIGH,
>> + "max77802 selb");
>> + if (ret) {
>> + dev_err(dev, "can't claim gpio[%d]: %d\n", i, ret);
>> + return ret;
>> + }
>
> Can this use the GPIO descriptor API?
>
Ok, I'll use gpiod_request() on v2.
>> +static void max77802_copy_reg(struct device *dev, struct regmap *regmap,
>> + int from_reg, int to_reg)
>> +{
>> + int val;
>> + int ret;
>> +
>> + if (from_reg == to_reg)
>> + return;
>> +
>> + ret = regmap_read(regmap, from_reg, &val);
>> + if (!ret)
>> + ret = regmap_write(regmap, to_reg, val);
>> +
>> + if (ret)
>> + dev_warn(dev, "Copy err %d => %d (%d)\n",
>> + from_reg, to_reg, ret);
>> +}
>
> This doesn't look at all device specific, better implement it in generic
> code.
>
Ok, will do.
>> + if (pdata->num_regulators != MAX77802_MAX_REGULATORS) {
>> + dev_err(&pdev->dev,
>> + "Invalid initial data for regulator's initialiation: " \
>> + "expected %d, pdata/dt provided %d\n",
>> + MAX77802_MAX_REGULATORS,
>> + pdata->num_regulators);
>> + return -EINVAL;
>> + }
>
> Don't split log messages over multiple lines so people can find the log
> message in the kernel source with grep, though in any case checking for
> this is a bug - the driver should always be at least able to read the
> current state from the hardware.
>
Ok.
>> +static int __init max77802_pmic_init(void)
>> +{
>> + return platform_driver_register(&max77802_pmic_driver);
>> +}
>> +subsys_initcall(max77802_pmic_init);
>
> module_platform_driver().
>
Ok.
Best regards,
Javier
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
