Re: [RFC PATCH v2 05/14] ARM: dts: samsung-fimd: add I80 specific properties

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi again,

On 04/17/2014 01:53 PM, YoungJun Cho wrote:
> In case of using CPU interface panel, the relevant registers should be set.
> So this patch adds relevant dt bindings.
>
> Changelog v2:
> - Changes "samsung,sysreg-phandle" to "samsung,sysreg"
>
> Signed-off-by: YoungJun Cho <yj44.cho@xxxxxxxxxxx>
> Signed-off-by: Inki Dae <inki.dae@xxxxxxxxxxx>
> Signed-off-by: Kyungmin Park <kyungmin.park@xxxxxxxxxxx>
> ---
>  .../devicetree/bindings/video/samsung-fimd.txt     |    9 +++++++++
>  1 file changed, 9 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/video/samsung-fimd.txt b/Documentation/devicetree/bindings/video/samsung-fimd.txt
> index 2dad41b..6ea1adc 100644
> --- a/Documentation/devicetree/bindings/video/samsung-fimd.txt
> +++ b/Documentation/devicetree/bindings/video/samsung-fimd.txt
> @@ -44,6 +44,15 @@ Optional Properties:
>  - display-timings: timing settings for FIMD, as described in document [1].
>  		Can be used in case timings cannot be provided otherwise
>  		or to override timings provided by the panel.
> +- samsung,sysreg: handle to syscon used to control the system registers
> +- vidout-i80-ldi: boolean to support i80 interface instead of rgb one
> +- cs-setup: clock cycles for the active period of address signal enable until
> +	chip select is enable in i80 interface
> +- wr-setup: clock cycles for the active period of CS signal enable until
> +	write signal is enable in i80 interface
> +- wr-act: clock cycles for the active period of CS enable in i80 interface
> +- wr-hold: clock cycles for the active period of CS disable until write signal
> +	is disable in i80 interface

As Laurent wrote earlier it would be good to consider providing these
properties
by panel. Panel can pass it to DSI probably via mipi_dsi_device
structure. DSI to FIMD
can use exynos drm_framework probably.
Anyway if you add optional properties please add info about default
value, ie when property
is not present.

Regards
Andrzej

>  
>  The device node can contain 'port' child nodes according to the bindings defined
>  in [2]. The following are properties specific to those nodes:

--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Linux SoC Development]     [Linux Rockchip Development]     [Linux USB Development]     [Video for Linux]     [Linux Audio Users]     [Linux SCSI]     [Yosemite News]

  Powered by Linux