>> ...although, the spec says that it does not wait for the port resets >> to complete. As far as I can see re-issuing a warm reset and waiting >> is the only way to guarantee the core times the recovery. Presumably >> the portstatus debounce in hub_activate() mitigates this, but that >> 100ms is less than a full reset timeout. It's definitely not just a timing issue for us. I can't reproduce all the same cases as Vikas, but when I attach a USB analyzer to the ones I do see the host controller doesn't even start sending a reset. >>> The xHCI spec requires that when the xHCI host is reset, a USB reset is >>> driven down the USB 3.0 ports. If hot reset fails, the port may migrate >>> to warm reset. See table 32 in the xHCI spec, in the definition of >>> HCRST. It sounds like this host doesn't drive a USB reset down USB 3.0 >>> ports at all on host controller reset? Oh, interesting, I hadn't seen that yet. So I guess the spec itself is fine if it were followed to the letter. I did some more tests about this on my Exynos machine: when I put a device to autosuspend (U3) and manually poke the xHC reset bit, I do see an automatic warm reset on the analyzer and the ports manage to retrain to U0. But after a system suspend/resume which calls xhci_reset() in the process, there is no reset on the wire. I also noticed that it doesn't drive a reset (even after manual poking) when there is no device connected on the other end of the analyzer. So this might be our problem: maybe these host controllers (Synopsys DesignWare) issue the spec-mandated warm reset only on ports where they think there is a device attached. But after a system suspend/resume (where the whole IP block on the SoC was powered down), the host controller cannot know that there is still a device with an active power session attached, and therefore doesn't drive the reset on its own. Even though this is a host controller bug, we still have to deal with it somehow. I guess we could move the code into xhci_plat_resume() and hide it behind a quirk to lessen the impact. But since reset_resume is not a common case for most host controllers, it's hard to say if this is DesignWare specific or a more widespread implementation mistake. -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |