Ok, I have one question when reading drivers/spi/spi-s3c64xx.c
In s3c64xx_spi_setup, cs->line(S3C64XX_GPC(3)) is set to
GPIOF_OUT_INIT_HIGH, that means an general output pin.
But the other three(clk, mosi, miso) was set to 2 by
s3c64xx_spi0_cfg_gpio. This is just what is needed by SPI.
My question is why wasn't cs->line also set to 2 to use SPI CS0?
When I want to use spi as slave side, should I set S3C64XX_GPC(3)'s cfg
of to 0(input) or 2?
In enable_cs, cs->line and SLAVE_SEL register were both actived, but
which one really take effect?
static inline void enable_cs(struct s3c64xx_spi_driver_data *sdd,
struct spi_device *spi)
{
struct s3c64xx_spi_csinfo *cs;
if (sdd->tgl_spi != NULL) { /* If last device toggled after mssg */
if (sdd->tgl_spi != spi) { /* if last mssg on diff device */
/* Deselect the last toggled device */
cs = sdd->tgl_spi->controller_data;
if (sdd->cs_gpio)
gpio_set_value(cs->line,
spi->mode & SPI_CS_HIGH ? 0 : 1);
}
sdd->tgl_spi = NULL;
}
cs = spi->controller_data;
if (sdd->cs_gpio)
gpio_set_value(cs->line, spi->mode & SPI_CS_HIGH ? 1 : 0);
/* Start the signals */
writel(0, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
}
thanks
ysh
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
