Hi Kishon, On Thu, Sep 12, 2013 at 05:43:40PM +0800, Kishon Vijay Abraham I wrote: > Hi, > > On Thursday 12 September 2013 03:00 PM, Pratyush Anand wrote: > > Hi Jingoo, > > > > > > On Thu, Sep 12, 2013 at 03:15:04PM +0800, Jingoo Han wrote: > >> On Tuesday 23 July 2013 12:30 PM, Kishon Vijay Abraham I wrote: > >>>>> . > >>>>> . > >>>>>>>> + of_pci_range_to_resource(&range, np, &pp->cfg); > >>>>>>>> + pp->config.cfg0_size = resource_size(&pp->cfg)/2; > >>>>>>>> + pp->config.cfg1_size = resource_size(&pp->cfg)/2; > >>>>>>>> + } > >>>>>>>> + } > >>>>>>>> + > >>>>>>>> + pp->dbi_base = devm_ioremap(pp->dev, pp->cfg.start, > >>>>>>>> + resource_size(&pp->cfg)); > >>>>>>> > >>>>>>> Why is configuraion space divided into two? > >>>>>> > >>>>>> Sorry, I don't know the exact reason. :( > >>>>>> Pratyush Anand may know about this. > >>>>>> Pratyush Anand, could you answer the question? > >>>>>> > >>>>>> Also, if you find some problems, please let me know. > >>> > >>> One more query.. > >>> > >>> Where is inbound translation configuration done in your driver? how should it > >>> be done? > >> > > > > Yes, Kishon is right. Inbound translation configuration is missing in > > your code and I think it should be implemented. > > > >> Hi Kishon, > >> > >> Sorry, I cannot understand your question exactly. > >> However, the following thread would be helpful. > >> > >> http://www.spinics.net/lists/arm-kernel/msg252078.html > >> https://lkml.org/lkml/2013/6/17/890 > > > > From this conversation, It seems that you > > have tested this driver and it works fine without inbound translation > > function. I am sure that you would have tested a PCIe card with DMA > > capability such as PCIe2USB or PCIe2Ethernet. Since it worked, it > > means that by default your controller is supporting one to one mapping > > in case of inbound transaction even when address translation is enabled. > > btw, I'm testing Ethernet controller: Realtek Semiconductor Co., Ltd. > RTL8111/8168B PCI Express Gigabit Ethernet controller. > > when I do ifconfig eth0 up, I get *r8169 0000:01:00.0 eth0: link up.* > But I dont receive any packets and ping also fails and the tx and rx packet > count is also 0. Could it be related to inbound translation? A PCIe analyser log would tell a definite cause. Most likely either inbound translation is not working or INTx/MSI is not working. Regards Pratyush > > Thanks > Kishon -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |