Ahh, one more thing inline.
On Wednesday 07 of August 2013 14:15:21 Padmavathi Venna wrote:
> Samsung has different versions of I2S introduced in different
> platforms. Each version has some new support added for multichannel,
> secondary fifo, s/w reset control and internal mux for rclk src clk.
> Each newly added change has a quirk. So this patch adds all the
> required quirks as driver data and based on compatible string from
> dtsi fetches the quirks.
>
> Signed-off-by: Padmavathi Venna <padma.v@xxxxxxxxxxx>
> ---
> .../devicetree/bindings/sound/samsung-i2s.txt | 21 +++---
> sound/soc/samsung/i2s.c | 82
> +++++++++++++------- 2 files changed, 64 insertions(+), 39 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/sound/samsung-i2s.txt
> b/Documentation/devicetree/bindings/sound/samsung-i2s.txt index
> 025e66b..b3f6443 100644
> --- a/Documentation/devicetree/bindings/sound/samsung-i2s.txt
> +++ b/Documentation/devicetree/bindings/sound/samsung-i2s.txt
> @@ -2,7 +2,16 @@
>
> Required SoC Specific Properties:
>
> -- compatible : "samsung,i2s-v5"
> +- compatible : should be one of the following.
> + - samsung,s3c6410-i2s: for 8/16/24bit stereo I2S. Previous versions
> + has only 8/16bit support.
> + - samsung,s3c6410-i2sv4: for 8/16/24bit multichannel(5.1 channel)
> I2S. + Introduced in s3c6410. This also applicable for s5p64x0
> platforms. + - samsung,s5pc100-i2s: for 8/16/24bit multichannel(5.1
> channel) I2S + with secondary fifo and s/w reset control.
> + - samsung,s5pv210-i2s: for 8/16/24bit multichannel(5.1) I2S with
> + secondary fifo, s/w reset control and internal mux for root clk
> src. +
> - reg: physical base address of the controller and length of memory
> mapped region.
> - dmas: list of DMA controller phandle and DMA request line ordered
> pairs. @@ -21,13 +30,6 @@ Required SoC Specific Properties:
>
> Optional SoC Specific Properties:
>
> -- samsung,supports-6ch: If the I2S Primary sound source has 5.1 Channel
> - support, this flag is enabled.
> -- samsung,supports-rstclr: This flag should be set if I2S software reset
> bit - control is required. When this flag is set I2S software reset bit
> will be - enabled or disabled based on need.
> -- samsung,supports-secdai:If I2S block has a secondary FIFO and internal
> DMA, - then this flag is enabled.
> - samsung,idma-addr: Internal DMA register base address of the audio
> sub system(used in secondary sound source).
> - pinctrl-0: Should specify pin control groups used for this controller.
> @@ -46,9 +48,6 @@ i2s0: i2s@03830000 {
> <&clock_audss EXYNOS_I2S_BUS>,
> <&clock_audss EXYNOS_SCLK_I2S>;
> clock-names = "iis", "i2s_opclk0", "i2s_opclk1";
> - samsung,supports-6ch;
> - samsung,supports-rstclr;
> - samsung,supports-secdai;
> samsung,idma-addr = <0x03000000>;
> pinctrl-names = "default";
> pinctrl-0 = <&i2s0_bus>;
> diff --git a/sound/soc/samsung/i2s.c b/sound/soc/samsung/i2s.c
> index 47e08dd..8a5504c 100644
> --- a/sound/soc/samsung/i2s.c
> +++ b/sound/soc/samsung/i2s.c
> @@ -40,6 +40,7 @@ enum samsung_dai_type {
>
> struct samsung_i2s_dai_data {
> int dai_type;
> + u32 quirks;
> };
>
> struct i2s_dai {
> @@ -1032,18 +1033,18 @@ static struct i2s_dai *i2s_alloc_dai(struct
> platform_device *pdev, bool sec)
>
> static const struct of_device_id exynos_i2s_match[];
>
> -static inline int samsung_i2s_get_driver_data(struct platform_device
> *pdev) +static inline struct samsung_i2s_dai_data
> *samsung_i2s_get_driver_data( + struct platform_device
*pdev)
> {
> #ifdef CONFIG_OF
> - struct samsung_i2s_dai_data *data;
> if (pdev->dev.of_node) {
> const struct of_device_id *match;
> match = of_match_node(exynos_i2s_match, pdev->dev.of_node);
> - data = (struct samsung_i2s_dai_data *) match->data;
> - return data->dai_type;
> + return (struct samsung_i2s_dai_data *) match->data;
> } else
> #endif
> - return platform_get_device_id(pdev)->driver_data;
> + return (struct samsung_i2s_dai_data *)
> + platform_get_device_id(pdev)->driver_data;
> }
>
> #ifdef CONFIG_PM_RUNTIME
> @@ -1074,13 +1075,13 @@ static int samsung_i2s_probe(struct
> platform_device *pdev) struct resource *res;
> u32 regs_base, quirks = 0, idma_addr = 0;
> struct device_node *np = pdev->dev.of_node;
> - enum samsung_dai_type samsung_dai_type;
> + struct samsung_i2s_dai_data *i2s_dai_data;
> int ret = 0;
>
> /* Call during Seconday interface registration */
> - samsung_dai_type = samsung_i2s_get_driver_data(pdev);
> + i2s_dai_data = samsung_i2s_get_driver_data(pdev);
>
> - if (samsung_dai_type == TYPE_SEC) {
> + if (i2s_dai_data->dai_type == TYPE_SEC) {
> sec_dai = dev_get_drvdata(&pdev->dev);
> if (!sec_dai) {
> dev_err(&pdev->dev, "Unable to get drvdata\n");
> @@ -1129,15 +1130,7 @@ static int samsung_i2s_probe(struct
> platform_device *pdev) idma_addr = i2s_cfg->idma_addr;
> }
> } else {
> - if (of_find_property(np, "samsung,supports-6ch", NULL))
> - quirks |= QUIRK_PRI_6CHAN;
> -
> - if (of_find_property(np, "samsung,supports-secdai", NULL))
> - quirks |= QUIRK_SEC_DAI;
> -
> - if (of_find_property(np, "samsung,supports-rstclr", NULL))
> - quirks |= QUIRK_NEED_RSTCLR;
> -
> + quirks = i2s_dai_data->quirks;
> if (of_property_read_u32(np, "samsung,idma-addr",
> &idma_addr)) {
> if (quirks & QUIRK_SEC_DAI) {
> @@ -1250,27 +1243,60 @@ static int samsung_i2s_remove(struct
> platform_device *pdev) return 0;
> }
>
> +static struct samsung_i2s_dai_data i2sv3_dai_type = {
> + .dai_type = TYPE_PRI,
> + .quirks = QUIRK_NO_MUXPSR,
> +};
> +
> +static struct samsung_i2s_dai_data i2sv4_dai_type = {
> + .dai_type = TYPE_PRI,
> + .quirks = QUIRK_PRI_6CHAN | QUIRK_NO_MUXPSR,
> +};
> +
> +static struct samsung_i2s_dai_data i2sv5_c100_dai_type = {
> + .dai_type = TYPE_PRI,
> + .quirks = QUIRK_PRI_6CHAN | QUIRK_NO_MUXPSR | QUIRK_SEC_DAI |
> + QUIRK_NEED_RSTCLR,
> +};
> +
> +static struct samsung_i2s_dai_data i2sv5_dai_type = {
> + .dai_type = TYPE_PRI,
> + .quirks = QUIRK_PRI_6CHAN | QUIRK_SEC_DAI | QUIRK_NEED_RSTCLR,
> +};
> +
> +static struct samsung_i2s_dai_data samsung_dai_type_sec = {
> + .dai_type = TYPE_SEC,
> +};
> +
> static struct platform_device_id samsung_i2s_driver_ids[] = {
> {
> - .name = "samsung-i2s",
> - .driver_data = TYPE_PRI,
> + .name = "samsung,s3c6410-i2s",
> + .driver_data = (kernel_ulong_t)&i2sv3_dai_type,
> + }, {
> + .name = "samsung,s3c6410-i2s-multi",
> + .driver_data = (kernel_ulong_t)&i2sv4_dai_type,
> + }, {
> + .name = "samsung,s5pc100-i2s",
> + .driver_data = (kernel_ulong_t)&i2sv5_c100_dai_type,
> }, {
> - .name = "samsung-i2s-sec",
> - .driver_data = TYPE_SEC,
> + .name = "samsung,s5pv210-i2s",
> + .driver_data = (kernel_ulong_t)&i2sv5_dai_type,
> + }, {
> + .name = "samsung-i2s-sec",
> + .driver_data = (kernel_ulong_t)&samsung_dai_type_sec,
I don't think you need to change the legacy platform IDs at all.
IMHO it would be better to keep the old way of quirk retrieval from
platform_data (which I think this patch does anyway, because the probe path
without DT is unchanged), as it will be dropped in some point in time
anyway.
This would also eliminate the need for patch 1.
Best regards,
Tomasz
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
