On Mon, Jul 29, 2013 at 02:44:13PM -0700, Julius Werner wrote:
> This patch simplifies the way the phy-samsung-usb code finds the correct
> power management register to enable PHY clock gating. Previously, the
> code would calculate the register address from a device tree supplied
> base address and add an offset based on the PHY type.
>
> Since every PHY has its own device tree entry and needs only one
> register, we can just encode the address itself in the device tree and
> remove the diffentiation in the code. The bitmask needed to specify the
> bit within that register stays in place, allowing support for platforms
> like s3c64xx that use different bits within the same register. Due to
> this simplification, the whole complication of a Samsung-specific USB
> PHY type can be removed from the PHY driver.
>
> Signed-off-by: Julius Werner <jwerner@xxxxxxxxxxxx>
alright, let's try to split this patch down, it's too large.
> diff --git a/arch/arm/boot/dts/exynos5250.dtsi b/arch/arm/boot/dts/exynos5250.dtsi
> index ef57277..5a754d7 100644
> --- a/arch/arm/boot/dts/exynos5250.dtsi
> +++ b/arch/arm/boot/dts/exynos5250.dtsi
> @@ -473,7 +473,7 @@
> ranges;
>
> usbphy-sys {
> - reg = <0x10040704 0x8>;
> + reg = <0x10040704 0x4>;
> };
> };
>
> @@ -505,7 +505,7 @@
> ranges;
>
> usbphy-sys {
> - reg = <0x10040704 0x8>,
> + reg = <0x10040708 0x4>,
> <0x10050230 0x4>;
> };
> };
> diff --git a/drivers/usb/phy/phy-samsung-usb.c b/drivers/usb/phy/phy-samsung-usb.c
> index ac025ca..32c5264 100644
> --- a/drivers/usb/phy/phy-samsung-usb.c
> +++ b/drivers/usb/phy/phy-samsung-usb.c
> @@ -27,7 +27,6 @@
> #include <linux/io.h>
> #include <linux/of.h>
> #include <linux/of_address.h>
> -#include <linux/usb/samsung_usb_phy.h>
>
> #include "phy-samsung-usb.h"
>
> @@ -42,9 +41,9 @@ int samsung_usbphy_parse_dt(struct samsung_usbphy *sphy)
> return -ENODEV;
> }
>
> - sphy->pmuregs = of_iomap(usbphy_sys, 0);
> + sphy->pmureg = of_iomap(usbphy_sys, 0);
this rename can go in a separate patch.
> @@ -75,35 +74,25 @@ EXPORT_SYMBOL_GPL(samsung_usbphy_parse_dt);
> */
> void samsung_usbphy_set_isolation_4210(struct samsung_usbphy *sphy, bool on)
> {
> - void __iomem *reg = NULL;
> u32 reg_val;
> - u32 en_mask = 0;
>
> - if (!sphy->pmuregs) {
> + if (!sphy->pmureg) {
> dev_warn(sphy->dev, "Can't set pmu isolation\n");
> return;
> }
>
> - if (sphy->phy_type == USB_PHY_TYPE_DEVICE) {
> - reg = sphy->pmuregs + sphy->drv_data->devphy_reg_offset;
> - en_mask = sphy->drv_data->devphy_en_mask;
> - } else if (sphy->phy_type == USB_PHY_TYPE_HOST) {
> - reg = sphy->pmuregs + sphy->drv_data->hostphy_reg_offset;
> - en_mask = sphy->drv_data->hostphy_en_mask;
> - }
>
> - reg_val = readl(reg);
> + reg_val = readl(sphy->pmureg);
>
> if (on)
> - reg_val &= ~en_mask;
> + reg_val &= ~sphy->drv_data->phy_en_mask;
> else
> - reg_val |= en_mask;
> + reg_val |= sphy->drv_data->phy_en_mask;
removing the if case up there and updating this if here could be a patch
of its own.
> @@ -111,7 +100,7 @@ EXPORT_SYMBOL_GPL(samsung_usbphy_set_isolation_4210);
> /*
> * Configure the mode of working of usb-phy here: HOST/DEVICE.
> */
> -void samsung_usbphy_cfg_sel(struct samsung_usbphy *sphy)
> +void samsung_usbphy_cfg_sel(struct samsung_usbphy *sphy, bool device_mode)
passing this extra parameter could be a patch of its own.
> @@ -122,31 +111,15 @@ void samsung_usbphy_cfg_sel(struct samsung_usbphy *sphy)
>
> reg = readl(sphy->sysreg);
>
> - if (sphy->phy_type == USB_PHY_TYPE_DEVICE)
> + if (device_mode)
> reg &= ~EXYNOS_USB20PHY_CFG_HOST_LINK;
> - else if (sphy->phy_type == USB_PHY_TYPE_HOST)
> + else
> reg |= EXYNOS_USB20PHY_CFG_HOST_LINK;
>
> writel(reg, sphy->sysreg);
> }
> EXPORT_SYMBOL_GPL(samsung_usbphy_cfg_sel);
>
> -/*
> - * PHYs are different for USB Device and USB Host.
> - * This make sure that correct PHY type is selected before
> - * any operation on PHY.
> - */
> -int samsung_usbphy_set_type(struct usb_phy *phy,
> - enum samsung_usb_phy_type phy_type)
> -{
> - struct samsung_usbphy *sphy = phy_to_sphy(phy);
> -
> - sphy->phy_type = phy_type;
> -
> - return 0;
> -}
> -EXPORT_SYMBOL_GPL(samsung_usbphy_set_type);
removing this function should be a patch of its own.
--
balbi
Attachment:
signature.asc
Description: Digital signature
