Doug Anderson wrote: > > From: Olof Johansson <olof@xxxxxxxxx> > > Add support for using UART3 for DEBUG_LL on exynos. > > [dianders: added depend on ARCH_EXYNOS.] > > Signed-off-by: Olof Johansson <olof@xxxxxxxxx> > Signed-off-by: Doug Anderson <dianders@xxxxxxxxxxxx> > > --- > Changes in v2: > - Matched Olof's commit message. > - Added ARCH_EXYNOS to depend list. > > arch/arm/Kconfig.debug | 11 +++++++++++ > arch/arm/plat-samsung/Kconfig | 1 + > 2 files changed, 12 insertions(+), 0 deletions(-) > > diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug > index 33a8930..f54f170 100644 > --- a/arch/arm/Kconfig.debug > +++ b/arch/arm/Kconfig.debug > @@ -355,6 +355,17 @@ choice > The uncompressor code port configuration is now handled > by CONFIG_S3C_LOWLEVEL_UART_PORT. > > + config DEBUG_S3C_UART3 > + depends on PLAT_SAMSUNG && ARCH_EXYNOS > + bool "Use S3C UART 3 for low-level debug" > + help > + Say Y here if you want the debug print routines to direct > + their output to UART 3. The port must have been initialised > + by the boot-loader before use. > + > + The uncompressor code port configuration is now handled > + by CONFIG_S3C_LOWLEVEL_UART_PORT. > + > config DEBUG_SOCFPGA_UART > depends on ARCH_SOCFPGA > bool "Use SOCFPGA UART for low-level debug" > diff --git a/arch/arm/plat-samsung/Kconfig b/arch/arm/plat-samsung/Kconfig > index 59401e1..d342ed0 100644 > --- a/arch/arm/plat-samsung/Kconfig > +++ b/arch/arm/plat-samsung/Kconfig > @@ -502,5 +502,6 @@ config DEBUG_S3C_UART > default "0" if DEBUG_S3C_UART0 > default "1" if DEBUG_S3C_UART1 > default "2" if DEBUG_S3C_UART2 > + default "3" if DEBUG_S3C_UART3 > > endif > -- > 1.7.7.3 Applied, thanks. Best regards, Kgene. -- Kukjin Kim <kgene.kim@xxxxxxxxxxx>, Senior Engineer, SW Solution Development Team, Samsung Electronics Co., Ltd. -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |