On 16 November 2012 19:58, Tomasz Figa <t.figa@xxxxxxxxxxx> wrote:
> This patch adds support for pin configuration using pinctrl subsystem
> to the sdhci-s3c driver.
>
> Signed-off-by: Tomasz Figa <t.figa@xxxxxxxxxxx>
> ---
> .../devicetree/bindings/mmc/samsung-sdhci.txt | 20 +++++++++++++-------
> drivers/mmc/host/sdhci-s3c.c | 12 ++++++++++--
> 2 files changed, 23 insertions(+), 9 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/mmc/samsung-sdhci.txt b/Documentation/devicetree/bindings/mmc/samsung-sdhci.txt
> index 630a7d7..97e9e31 100644
> --- a/Documentation/devicetree/bindings/mmc/samsung-sdhci.txt
> +++ b/Documentation/devicetree/bindings/mmc/samsung-sdhci.txt
> @@ -12,10 +12,6 @@ is used. The Samsung's SDHCI controller bindings extends this as listed below.
> [A] The property "samsung,cd-pinmux-gpio" can be used as stated in the
> "Optional Board Specific Properties" section below.
>
> -[B] If core card-detect bindings and "samsung,cd-pinmux-gpio" property
> - is not specified, it is assumed that there is no card detection
> - mechanism used.
> -
> Required SoC Specific Properties:
> - compatible: should be one of the following
> - "samsung,s3c6410-sdhci": For controllers compatible with s3c6410 sdhci
> @@ -24,14 +20,18 @@ Required SoC Specific Properties:
> controller.
>
> Required Board Specific Properties:
> -- gpios: Should specify the gpios used for clock, command and data lines. The
> - gpio specifier format depends on the gpio controller.
> +- Samsung GPIO variant (will be completely replaced by pinctrl):
> + - gpios: Should specify the gpios used for clock, command and data lines. The
> + gpio specifier format depends on the gpio controller.
> +- Pinctrl variant (preferred if available):
> + - pinctrl-0: Should specify pin control groups used for this controller.
> + - pinctrl-names: Should contain only one value - "default".
>
> Optional Board Specific Properties:
> - samsung,cd-pinmux-gpio: Specifies the card detect line that is routed
> through a pinmux to the card-detect pin of the card slot. This property
> should be used only if none of the mmc core card-detect properties are
> - used.
> + used. Only for Samsung GPIO variant.
>
> Example:
> sdhci@12530000 {
> @@ -40,12 +40,18 @@ Example:
> interrupts = <0 75 0>;
> bus-width = <4>;
> cd-gpios = <&gpk2 2 2 3 3>;
> +
> + /* Samsung GPIO variant */
> gpios = <&gpk2 0 2 0 3>, /* clock line */
> <&gpk2 1 2 0 3>, /* command line */
> <&gpk2 3 2 3 3>, /* data line 0 */
> <&gpk2 4 2 3 3>, /* data line 1 */
> <&gpk2 5 2 3 3>, /* data line 2 */
> <&gpk2 6 2 3 3>; /* data line 3 */
> +
> + /* Pinctrl variant */
> + pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_bus4>;
> + pinctrl-names = "default";
> };
nit: there could have been one example each for gpio and pinctrl
variant instead of putting both into one example node.
>
> Note: This example shows both SoC specific and board specific properties
> diff --git a/drivers/mmc/host/sdhci-s3c.c b/drivers/mmc/host/sdhci-s3c.c
> index 75f85fd..6161162 100644
> --- a/drivers/mmc/host/sdhci-s3c.c
> +++ b/drivers/mmc/host/sdhci-s3c.c
> @@ -24,6 +24,7 @@
> #include <linux/of_gpio.h>
> #include <linux/pm.h>
> #include <linux/pm_runtime.h>
> +#include <linux/pinctrl/consumer.h>
>
> #include <linux/mmc/host.h>
>
> @@ -57,6 +58,7 @@ struct sdhci_s3c {
> int ext_cd_irq;
> int ext_cd_gpio;
> int *gpios;
> + struct pinctrl *pctrl;
>
> struct clk *clk_io;
> struct clk *clk_bus[MAX_BUS_CLK];
> @@ -477,8 +479,9 @@ static int __devinit sdhci_s3c_parse_dt(struct device *dev,
> return -EINVAL;
> }
>
> - dev_info(dev, "assuming no card detect line available\n");
> - pdata->cd_type = S3C_SDHCI_CD_NONE;
> + /* assuming internal card detect that will be configured by pinctrl */
> + pdata->cd_type = S3C_SDHCI_CD_INTERNAL;
> + goto setup_bus;
>
> found_cd:
> if (pdata->cd_type == S3C_SDHCI_CD_GPIO) {
> @@ -496,6 +499,9 @@ static int __devinit sdhci_s3c_parse_dt(struct device *dev,
> }
>
> setup_bus:
> + if (!IS_ERR(ourhost->pctrl))
> + return 0;
> +
> /* get the gpios for command, clock and data lines */
> for (cnt = 0; cnt < NUM_GPIOS(pdata->max_width); cnt++) {
> gpio = of_get_gpio(node, cnt);
> @@ -574,6 +580,8 @@ static int __devinit sdhci_s3c_probe(struct platform_device *pdev)
> goto err_pdata_io_clk;
> }
>
> + sc->pctrl = devm_pinctrl_get_select_default(&pdev->dev);
> +
> if (pdev->dev.of_node) {
> ret = sdhci_s3c_parse_dt(&pdev->dev, host, pdata);
> if (ret)
> --
> 1.8.0
Acked-by: Thomas Abraham <thomas.abraham@xxxxxxxxxx>
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
