> -----Original Message----- > From: Joonyoung Shim [mailto:jy0922.shim@xxxxxxxxxxx] > Sent: Thursday, September 27, 2012 1:50 PM > To: Eunki Kim > Cc: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx; linux-samsung-soc@xxxxxxxxxxxxxxx; > grant.likely@xxxxxxxxxxxx; linus.walleij@xxxxxxxxxx; kgene.kim@xxxxxxxxxxx > Subject: Re: [PATCH 1/2] ARM: SAMSUNG: Insert bitmap_gpio_int member in samsung_gpio_chip > > On 09/27/2012 12:55 PM, Eunki Kim wrote: > > When a device uses GPIO interrupt, its driver assumes that GPIO should > > be INPUT mode. However, GPIO of SAMSUNG SoC is sepated to INPUT mode > > and INTERRUPT mode. They are set by 0x0 and 0xF in GPIO control > > register. If the register is set to INPUT mode, the interrupt never > > occur. Therefore, it's necessary to set INTERRUPT mode instead of > > INPUT mode when the pin is used for GPIO interrupt. > > If for this, already the patch was posted. > > http://lists.infradead.org/pipermail/linux-arm-kernel/2011-November/074387.html > > Thanks. > The old posted patch and my new patches solve the same problem. However, the old patch fixes s5p_gpioint_set_type function which is irq_set_type function of GPIO int. The objective of irq_set_type function is setting IRQ type as rising, falling, level and etc. It's not setting GPIO pin configuration. The new patches solve the problem root. It monitors use of GPIO int for each pin. If then, it sets INTERRUPT mode instead of INPUT mode when gpio_direction_input function is called. As you know, the objective of gpio_direction_input function is setting the GPIO configuration. > > This patch inserts the bitmap_gpio_int member in struct samsung_ > > gpio_chip in order to represent use of GPIO interrupt for each pin and > > sets the related bit when s5p_register_gpio_interrupt function is > > called. > > > > Signed-off-by: Eunki Kim <eunki_kim@xxxxxxxxxxx> > > Cc: Grant Likely <grant.likely@xxxxxxxxxxxx> > > Cc: Linus Walleij <linus.walleij@xxxxxxxxxx> > > --- > > arch/arm/plat-samsung/include/plat/gpio-core.h | 2 ++ > > arch/arm/plat-samsung/s5p-irq-gpioint.c | 8 ++++++-- > > 2 files changed, 8 insertions(+), 2 deletions(-) > > > > diff --git a/arch/arm/plat-samsung/include/plat/gpio-core.h > > b/arch/arm/plat-samsung/include/plat/gpio-core.h > > index 1fe6917..dfd8b7a 100644 > > --- a/arch/arm/plat-samsung/include/plat/gpio-core.h > > +++ b/arch/arm/plat-samsung/include/plat/gpio-core.h > > @@ -48,6 +48,7 @@ struct samsung_gpio_cfg; > > * @config: special function and pull-resistor control information. > > * @lock: Lock for exclusive access to this gpio bank. > > * @pm_save: Save information for suspend/resume support. > > + * @bitmap_gpio_int: Bitmap for representing GPIO interrupt or not. > > * > > * This wrapper provides the necessary information for the Samsung > > * specific gpios being registered with gpiolib. > > @@ -71,6 +72,7 @@ struct samsung_gpio_chip { > > #ifdef CONFIG_PM > > u32 pm_save[4]; > > #endif > > + u32 bitmap_gpio_int; > > }; > > > > static inline struct samsung_gpio_chip *to_samsung_gpio(struct > > gpio_chip *gpc) diff --git a/arch/arm/plat-samsung/s5p-irq-gpioint.c > > b/arch/arm/plat-samsung/s5p-irq-gpioint.c > > index f9431fe..d981c61 100644 > > --- a/arch/arm/plat-samsung/s5p-irq-gpioint.c > > +++ b/arch/arm/plat-samsung/s5p-irq-gpioint.c > > @@ -185,7 +185,7 @@ int __init s5p_register_gpio_interrupt(int pin) > > > > /* check if the group has been already registered */ > > if (my_chip->irq_base) > > - return my_chip->irq_base + offset; > > + goto success; > > > > /* register gpio group */ > > ret = s5p_gpioint_add(my_chip); > > @@ -193,9 +193,13 @@ int __init s5p_register_gpio_interrupt(int pin) > > my_chip->chip.to_irq = samsung_gpiolib_to_irq; > > printk(KERN_INFO "Registered interrupt support for gpio group %d.\n", > > group); > > - return my_chip->irq_base + offset; > > + goto success; > > } > > return ret; > > +success: > > + my_chip->bitmap_gpio_int |= BIT(offset); > > + > > + return my_chip->irq_base + offset; > > } > > > > int __init s5p_register_gpioint_bank(int chain_irq, int start, int > > nr_groups) -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |