Hi, On Mon, Aug 27, 2012 at 11:01 AM, Heiko Stübner <heiko@xxxxxxxxx> wrote: > Hi Thomas, > > thanks for your review: > > Hmmm, but the logic to drive the gpio controller is the same for all arches. > The only difference is the number to use for the different pull up/down > settings. So I think the "samsung,s3c24xx-gpio" is ok but the documentation > should simply reflect the different pull settings. > Also s3c2410 and s3c2440 has different count of GPIOs. And that could be a problem on machines with GPIO-expanders (h1940 machine) >> It would be informative to add information about the 'mux function' >> cell here as well. Specifically, on how to handle the banks that have >> an extended GPxSEL register that allow additional pin function >> selection. > > Will add a mux function description. > > Until now I've never realised the existence of the GPxSEL registers, so thanks > for the pointer :-). > > But is this used in the driver at all? All the setcfg/getcfg functions in > gpio-samsung.c only handle the GPxCON registers - I haven't found code to > handle the GPxSEL registers at all. So my guess is that this was never > implemented - or that I'm blind ;-) . There're no GPxSEL registers on s3c2410/s3c2440/s3c2442. Is it something s3c2412/sec2416 specific? Regards Vasily -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |