Mark Brown wrote:
>
> Use the new irqdomain support in the WM8994 driver to dynamically allocate
> the interrupt range for the WM8994 rather than doing it explicitly. This
> is more idiomatic for modern interrupt usage.
>
> Signed-off-by: Mark Brown <broonie@xxxxxxxxxxxxxxxxxxxxxxxxxxx>
> ---
> arch/arm/mach-s3c64xx/include/mach/crag6410.h | 1 -
> arch/arm/mach-s3c64xx/mach-crag6410-module.c | 1 -
> 2 files changed, 2 deletions(-)
>
> diff --git a/arch/arm/mach-s3c64xx/include/mach/crag6410.h
> b/arch/arm/mach-s3c64xx/include/mach/crag6410.h
> index 4cb2f951..ec97c15 100644
> --- a/arch/arm/mach-s3c64xx/include/mach/crag6410.h
> +++ b/arch/arm/mach-s3c64xx/include/mach/crag6410.h
> @@ -15,7 +15,6 @@
>
> #define BANFF_PMIC_IRQ_BASE IRQ_BOARD_START
> #define GLENFARCLAS_PMIC_IRQ_BASE (IRQ_BOARD_START + 64)
> -#define CODEC_IRQ_BASE (IRQ_BOARD_START + 128)
>
> #define PCA935X_GPIO_BASE GPIO_BOARD_START
> #define CODEC_GPIO_BASE (GPIO_BOARD_START + 8)
> diff --git a/arch/arm/mach-s3c64xx/mach-crag6410-module.c b/arch/arm/mach-
> s3c64xx/mach-crag6410-module.c
> index 4979372..4a83b4e 100644
> --- a/arch/arm/mach-s3c64xx/mach-crag6410-module.c
> +++ b/arch/arm/mach-s3c64xx/mach-crag6410-module.c
> @@ -168,7 +168,6 @@ static struct wm8994_pdata wm8994_pdata = {
> .gpio_defaults = {
> 0x3, /* IRQ out, active high, CMOS */
> },
> - .irq_base = CODEC_IRQ_BASE,
> .ldo = {
> { .init_data = &wm8994_ldo1, },
> { .init_data = &wm8994_ldo2, },
> --
> 1.7.10
Yeah, I agree with your comments. Will apply.
Thanks.
Best regards,
Kgene.
--
Kukjin Kim <kgene.kim@xxxxxxxxxxx>, Senior Engineer,
SW Solution Development Team, Samsung Electronics Co., Ltd.
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
